Filter
Top Products
Before Using the CD Receiver
6
Installing the Batteries
1
Open the battery compartment, as
shown.
2
Insert two batteries (R6 / AA) into the
battery compartment.
Carefully follow the polarity diagram
(positive (+) and negative (–) symbols)
inside the battery compartment.
3
After the batteries are installed and
seated correctly, attach the
compartment cover.
Notes:
• If the remote controller doesn’t work reliably, try
replacing the batteries.
• Don’t mix new and old batteries or different
types of batteries.
• If you intend not to use the remote controller for
a long time, remove the batteries to prevent
damage from leakage or corrosion.
• Expired batteries should be removed as soon as
possible to prevent damage from leakage or
corrosion.
Using the Remote Controller
When you operate the remote controller, point it at
the CD receiver’s remote control sensor.
Notes:
•
The remote controller may not work reliably if
the CD receiver is subjected to bright light, such
as direct sunlight or inverter-type fluorescent
lights. Keep this in mind when installing.
•
If another remote controller of the same type is
used in the same room, or the CD receiver is
installed close to equipment that uses infrared
rays, the remote controller may not work reliably.
•
Don’t put anything, such as a book, on the
remote controller because the buttons may be
pressed inadvertently, thereby draining the
batteries.
•
The remote controller may not work reliably if
the CD receiver is installed in a rack behind
colored glass doors. Keep this in mind when
installing.
•
The remote controller will not work if there’s an
obstacle between it and the CD receiver’s remote
control sensor.
A
p
p
r
ox
.
5
m
(
1
6
f
t
.
)
Remote control senso
r