Filter
Top Products
Basic Operations
18
Turning On the CD Receiver
To turn on the CD receiver, press the
[ON/STANDBY] button on the CD receiver or
remote controller. The STANDBY indicator goes
off.
Press the [ON/STANDBY] button again to set the
CD receiver to Standby. The STANDBY indicator
lights up.
Adjusting the Volume
Turn the [VOLUME] control clockwise to increase
the volume or counterclockwise to decrease it.
You can also use remote controller’s VOLUME
[ ] / [ ] buttons.
Selecting the Input Source
Press the remote controller’s INPUT [ ] / [ ]
buttons repeatedly in order to select the input
source. On the CD receiver, press the [INPUT]
button repeatedly. The input sources are selected in
the following order.
Using Headphones
Turn down the volume, then connect your stereo
headphones to the PHONES minijack.
The speakers output no sound while the
headphones are connected.
Note:
When you select iPod as the input source, the
headphones output no sound. If use headphones,
connect it directly to iPod.
Muting the Sound
To mute the output of the CD receiver, press the
remote controller’s [MUTING] button. The
MUTING indicator flashes on the display.
To unmute the CD receiver, press the [MUTING]
button again.
Tips:
While the CD receiver is muted:
• Turning the [VOLUME] control on the CD
receiver or use the VOLUME [ ] / [ ]
buttons on the remote controller will unmute
the CD receiver.
• If you turn the CD receiver off and on, the CD
receiver will be unmuted.