Filter
Top Products
Troubleshooting—Continued
41
CD Playback
Playback jumps.
• The CD receiver is being subjected to vibration or the disc is scratched or dirty (see pages 11 to 12).
Can’t add tracks to the playlist for memory playback.
• Make sure there’s a disc in the CD receiver. Also, you can only add valid track numbers. For example, if the
CD contains 11 tracks, you cannot add track #12.
The disc will not play.
• Make sure the disc has been loaded correctly, with the label-side facing up.
• Check to see if the surface of the disc is dirty (see pages 11 to 12).
• If condensation is suspected, unplug the power cord and leave CD receiver for two to three hours in the room
temperature before playing any discs.
• Some CD-R / RW discs may not be playable (see page 11).
It takes a long time for playback to start.
• It may take the CD receiver a while to read CDs that contain many tracks or files.
Can’t play MP3 / WMA DISCs.
• Use only ISO 9660 Level 1 or Level 2 format discs (see page 11).
• The disc has not been finalized. Finalize the disc.
• Check whether the file format is supported (see page 11).
• MP3 / WMA files without a “.MP3 / .WMA” or “.mp3 / .wma” filename extension are not recognized.
Tuner
Reception is noisy, stereo FM reception suffers from hiss, the Auto Preset function doesn’t
preset all stations, or the ST indicator doesn’t light up when tuned to a stereo FM station.
• Check the antenna connections (see pages 13 to 14).
• Change the position of the antenna (see page 30).
• Move the CD receiver away from a nearby TV or computer.
• Cars or airplanes can cause noisy interference.
• The radio signal will be weakened if it has to pass through a concrete wall before reaching the antenna.
• Try setting FM mode to mono (see page 30).
• Move power cords and speaker cables as far away as possible from the tuner’s antenna.
• When listening to an AM station, noise may be heard when you operate the remote controller.
• If none of the above improves the reception, install an outdoor antenna (see page 14).
If a power outage occurs or the power cable is disconnected.
• If the preset stations are lost, preset them again (see page 31).
• The clock and timer settings will be lost. Set the clock and timers again (see pages 36 to 39).
Can’t adjust the frequency of the radio.
• Use the remote controller’s [ ] / [ ] buttons to change the frequency of the radio.
iPod / iPhone
“Cannot Use HP” appears on the display.
• When you select iPod as the input source, the headphones output no sound. Remove the headphones and use
the speaker. If use headphones, connect it directly to iPod.
No sound
• Make sure that your iPod is compatible with the system (see page 5).
• Make sure that the iPod is securely inserted in the dock. Remove your iPod from its case before inserting it.
• Confirm that the CD receiver’s INPUT is set to iPod, and that the iPod is set to PLAY.
iPod does not respond to the CD receiver buttons or enclosed remote control.
• Confirm that the CD receiver’s INPUT is set to iPod.
• Make sure that the iPod is securely inserted in the dock. Remove your iPod from its case before inserting it.
• If the iPod is sleeping, wait for the iPod to wake up and start.
• If “iPod No Device” is displayed, or “Reading” is displayed for a minute or more, remove your iPod once,
wait a few moments and then connect it again.