Filter
Top Products
24
Symptom
STANDBY button is pressed,
but power does not come
on.
Disc is loaded in the disc
tray, but playback will not
begin.
No sound
Disc skipping
Search time (when moving
to a specific track) is
extremely long.
Track numbers cannot be
stored in memory.
Noise during play
Remote control does not
function.
The unit does not operate.
Troubleshooting
Remedy
• Insert the plug firmly.
(See pages 11.)
• Load the disc with the label facing
upward.
• Clean the disc. (See page 23.)
• Remove the disc from the disc tray,
place the CD Changer in a warm
place and leave the power on for
about one hour. (See page 4).
• Load the disc properly in the disc
tray.
• Insert all plugs firmly into jacks.
(See pages 8-9.)
• Clean the disc. (See page 23)
• Replace the disc.
• Place the CD Changer in a more
stable location.
• Clean the disc. (See page 23)
• Replace the disc.
• Load a disc into the tray.
• Use only the track numbers on
the disc. (See pages 18-20.)
• Turn off the TV, or move the unit
farther from the TV.
• Replace the batteries.
• Remote control is possible within
a distance of approximately 5
meters from the unit’s sensor and
a detection range of 30°.
(See pages 11.)
• Operate from a different position
or remove the obstacle.
• Remove the power plug, wait for
approx. 5 seconds, and then re-
insert the power plug.
Cause
• Power cord plug is not properly
connected to AC outlet.
• Disc is in the disc tray upside
down.
• Disc is dirty.
• Moisture has accumulated inside
the CD Changer.
• Disc in the disc tray is loaded off-
center.
• Incomplete or incorrect
connections.
• Disc is dirty.
• Disc is scratched.
• CD Changer has been bumped.
• Disc is dirty.
• Disc is scratched.
• No disc in the tray.
• A track number not on the disc is
being input.
• Interference from TV
• Battery level is low.
• Your position is too far from the
unit’s remote control sensor or
out of the sensor’s detection
angle.
• An obstacle exists between you
and the unit’s remote control
sensor.
• A failure occurred in the unit's
microprocessor.
If you have any problems with the unit, please check the troubleshooting table below first.
For any problems not described in the table, please consult your nearest Onkyo authorized service
center.