Filter
Top Products
11
Before Using
Connections
Other Information
Operations
30¡
5m
30¡
C-707CHX
R-805X
RC-414S / RC-456S
Connecting the power cord
(mains lead)
Insert the AC power cord (mains lead)
into a wall outlet. The STANDBY indi-
cator lights.
• If you press the OPEN/CLOSE button while
the unit is in the standby mode, the power
will turn on and the display will light up auto-
matically.
• To use the unit with the other Onkyo Sepa-
rate Collection series components, follow the
connection diagram in the R-805X instruction
manual to connect the unit to the system.
Using the remote controller
The unit is not shipped with a remote controller.
However, you can use a remote controller (RC-
414S/RC-456S) that is shipped with the R-805X
amplifier.
Remote controller RC-414S/RC-456S
When the remote controller RC-414S/RC-456S
supplied with the amplifier R-805X is used, oper-
ate the remote controller pointing towards the
amplifier’s remote sensor.
Be sure to make the
connection securely. If
the connection is incomplete, you cannot use the
remote controller to operate the unit.
Remote control
sensor
STANDBY
STANDBY/ON
The RC-414S remote controller is shown in
the following illustrations.
Notes
• Place the unit away from strong light such as
direct sunlight or inverted fluorescent light which
can prevent proper operation of the remote con-
troller.
• Using another remote controller of the same
type in the same room or using the unit near
equipment which uses infrared rays may cause
operational interference.
• Do not put any object such as a book on the
remote controller. The buttons of the remote
controller may be pressed by mistake and drain
the batteries.
• Make sure the audio rack doors do not have
colored glass. Placing the unit behind such doors
may prevent proper remote controller operation.
• If there is any obstacle between the remote con-
troller and the remote control sensor, the re-
mote controller will not operate.