Filter
Top Products
49
Advanced Setup
—Continued
Notes:
• The Center and Subwoofer distances can be set up to
5 ft. (1.5 m) more or less than the Front distance. For
example, if the Front distance is set to 20 ft. (6 m), the
Center and Subwoofer distances can be set between 15
and 25 ft. (4.5 and 7.5 m).
• The SurrRight, Surr Left, and Surr Back distances can
be set up to 5 ft. (1.5 m) more or 15 ft. (4.5 m) less
than the Front distance. For example, if the Front dis-
tance is set to 20 ft. (6 m), the SurrRight, Surr Left,
and Surr Back distances can be set between 5 and 25
ft. (1.5 and 7.5 m).
With this function you can adjust the volume of each
speaker so that all speakers can be heard equally at the
listening position.
Notes:
• This procedure can also be performed by using the
remote controller. First press the [TEST TONE] but-
ton to output the test tone. Use the [LEVEL–] and
[LEVEL+] buttons to adjust the levels, and use the
[CH SEL] button to select the speakers.
5
Use the Left and Right [ ]/[ ]
buttons to specify the distance
for “Front,” then press the Down
[] button to select the next
speaker.
6
Repeat step 5 for all speakers.
Note:
Speakers that you set to No or None in
the Speaker Configuration (page 32)
cannot be selected.
7
Press the [SETUP] button.
Setup closes.
Speaker Levels
1
Press the [AMP] button followed
by the [SETUP] button on the
remote controller.
ENTER
Speaker levels cannot be set while the AV
Receiver is muted.
AMP
2
Use the Up and Down [ ]/[ ]
buttons to select “3. Level Cal,”
and then press the [ENTER] but-
ton.
A pink noise test tone is output by the
front left speaker.
3
Turn up the volume so that you
can hear the test tone suffi-
ciently.
While each speaker outputs the test
tone, its name appears on the display, as
shown.
4
Use the Left and Right [ ]/[ ]
buttons to adjust the speaker
level, and use the Down [ ] but-
ton to select the next speaker.
The level can be adjusted from –12 to
+12 dB in 1 dB steps (–15 to +12 dB
for the subwoofer).
5
Repeat step 4 so that the level of
the test tone from each speaker
is the same.
Speakers that you set to No or None in
the Speaker Configuration (page 32) do
not output the test tone.
6
Press the [SETUP] button.
Setup closes.
Don’t forget to turn down the volume if
you turned it up while setting the levels.
ENTER
ENTER
ENTER
ENTER