Filter
Top Products
39
Common Functions
—Continued
With this function you can temporarily mute the output
of the AV Receiver.
To unmute the AV Receiver,
press the remote control-
ler’s [MUTING] button again, or adjust the volume. The
output is unmuted and the MUTING indicator goes off.
Muting is cancelled when the AV Receiver is set to
Standby.
You can adjust individual speaker levels while listening
to an input source. These temporary adjustments are can-
celled when the AV Receiver is set to Standby.
Notes:
•You cannot use this function while the AV Receiver is
muted.
• Speakers that are set to No or None in the Speaker
Configuration cannot be adjusted.
With the sleep timer you can set the AV Receiver so that
it automatically turns off after a set period.
To cancel the sleep timer,
press the [SLEEP] button
repeatedly until the SLEEP indicator disappears.
To check the remaining sleep time,
press the [SLEEP]
button. Note that if you press the [SLEEP] button while
the sleep time is being displayed, you’ll shorten the sleep
time by 10 minutes.
You can connect a pair of stereo headphones (1/4-inch
phone plug) to the AV Receiver’s PHONES jack for pri-
vate listening, as shown.
Notes:
•Always turn down the volume before connecting your
headphones.
• Speaker sets A and B are turned off while the head-
phones plug is inserted in the PHONES jack.
• When you connect a pair of headphones, the listening
mode is set to Stereo, unless it’s already set to Pure
Audio, Stereo or Direct. When you disconnect the
headphones, the previous listening mode is selected.
• When the multichannel DVD input is selected, only
the front left and front right sounds can be heard in the
headphones.
Muting the AV Receiver
Press the remote controller’s
[MUTING] button.
The output is muted and the MUTING
indicator flashes on the display, as
shown.
Adjusting Speaker Levels
Temporarily
1
Use the remote controller’s
[CH SEL] button to select each
speaker, and use the [LEVEL–]
and [LEVEL+] buttons to adjust
the volume.
Speakers are selected in the following
order: Left
→
Center
→
Right
→
Surr
Right
→
Surr Back
→
Surr Left
→
Subwoofer.
You can adjust the volume of each
speaker from –12 dB to +12 dB
(–15 dB to +12 dB for the subwoofer).
The name of the currently selected
speaker and its volume appear on the
display, as shown.
MUTING
CH SEL
LEVEL
+
LEVEL
-
Using the Sleep Timer
Press the [SLEEP] button repeat-
edly to select the required sleep
time.
You can set the sleep time from 90 to 10
minutes in 10 minute steps.
The SLEEP indicator appears on the
display when the sleep timer has been
set, as shown. The specified sleep time
appears on the display for about five
seconds, then the previous display
reappears.
Using Headphones
SLEEP
SLEEP indicator
STANDBY/ON
POWER
PHONES
OFFON
SPEAKERS BA