Filter
Top Products
20
Connecting the AV receiver—Continued
Connecting the Speaker Cables
Terminal posts
Push terminals
The following illustration shows which speaker should be connected to each pair of terminals for up to 7.1-channel
playback.
If you’re using only one surround back speaker, connect it to the power amplifier’s left terminals.
Notes:
• The speakers are configured by using the “Speaker Settings” on page 44 and “Speaker Setup” on page 68.
• When you connect the front high left and right speakers, preparate it sepalately.
1
Strip 1/2"-5/8" (12-
15 mm) of insulation
from the ends of the
speaker cables. (Supplied
speaker cables are already
stripped.)
2
Unscrew the terminal. Fully insert the bare wire,
making sure that it’s touching the threaded shaft
in the center. Screw the terminal tight.
1/2"-5/8" (12-15 mm)
1
Strip 3/8"-1/2"
(10-12 mm) of insulation
from the ends of the
speaker cables, and twist
the bare wires tightly, as
shown.
2
While pressing the lever, insert
the wire into the hole, and then
release the lever.
Make sure that the terminals are
gripping the bare wires, not the
insulation.
3/8"-1/2" (10-12 mm)
Surround
right
speaker
Front right
speaker
Front left
speaker
Surround
back left
speaker
Surround
left
speaker
Surround
back right
speaker
Center
speaker
Front high
right speaker
(Optional)
Front high
left speaker
(Optional)
Powered
Subwoofer
Brown
Tan
Blue
Gray
Green
Red
White