Filter
Top Products
NIStune Type 1 Hardware Installation Page 27 of 27
7. Securing The Board
Is is the responsbility of the installer to ensure that an vibration that the ECU is subjected with the installed
NIStune board (ie unsurfaced roads, train lines, speed humps, grates etc) will not affect to operation of the
vehicle.
The NIStune board must be installed using machine drill pin sockets which ensure firm connection to the
ECU. However the board itself must also be secured to the ECU through suitable means (such as hot glue)
to surrounding components.
Also be aware that surrounding components are sprayed with conformal coating. This coating may lift
during vehicle operation and hot glue may become separated from components. Ensure that either
conformal coating is removed where hot glue is adhered to, or sufficient coverage of circuit board
components is made such that vibration will not affect the adhering of hot glue.
WARNING: If removable jumpers are not secured correctly and temporarily or permanently become
disconnected, ECU will not function. Note that the four pin header must be also secured using hot
glue or similar method.