Filter
Top Products
(continued on next page)
21NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373
Press the + button to confirm the erase procedure. The display will
show [MASTER DEFAULT RESTORED].
MASTER
DEFAULT RESTORED
Press the – button (at either screen) to exit and move to the next step
without erasing any information.
To continue to the first configuration step, MASTER/SLAVE, press the
Set button.
To save the settings and exit configuration mode, simultaneously
hold down the Band and Set buttons. After the ZR-4 saves the
information, [RELEASE BUTTONS TO CONTINUE] appears on the
display. The ZR-4 will return to the normal operating mode.
SETTING UP THE AM/FM TUNER
The built-in tuner can store up to twenty presets in any combination
of AM or FM stations. In Master/Slave configurations, each
tuner could store different presets providing a system total of 40.
However, each keypad can only operate the tuner in the ZR-4
MultiZone Receiver to which it is connected, so each zone has
access to 20 presets.
TO STORE PRESETS IN THE TUNER:
Press the Band button to choose between AM or FM. The display will
show AM or FM to indicate the current band along with the current
station [AM560].
AM 560
Press the + or – button to tune to the desired station. Each press and
release will increment the tuner frequency up or down. A press-and-
hold initiates the seek function. The tuner will move up or down to
the next station with a clear signal. Continuing to hold the button will
cause the tuner to pause at any station for 3 seconds before seeking
the next station. Releasing the button will stop the seek function and
the tuner will remain on the last tuned station.
FM 93.1
Once the desired station is displayed, press-and-hold the Set button
(2 seconds). The display will change to [PRESET XX SAVE] where XX
is the next available open preset.
FM 93.1
PRESET 01 SAVE
Press the + or – buttons until the desired preset location is displayed
(01 – 20). It will always stop at the first available blank preset. Press
the + or – button to overwrite any previously saved preset.
FM 93.1
PRESET 01
NOTE: IF THE SELECTED PRESET ALREADY HAS A STATION ASSIGNED, IT
WILL BE OVERWRITTEN AND THE NEW STATION WILL NOW BE STORED IN
THAT PRESET LOCATION.
Press-and-hold the Set button for 2 seconds. This will save the
station in the displayed preset location. The ZR-4 MultiZone Receiver
will return to normal operation. The display will show the station and
the preset.
FM 94.9
PRESET 2
Repeat these steps until all desired stations are preset or the available
twenty presets are filled.
Presets may be erased one of two ways: by storing a new preset in
the location; or by entering configuration mode and electing to erase
all presets (see “
Erasing Tuner Preset Information
”).
CONFIGURING THE ZONE