Filter
Top Products
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-437320
DEFAULT TURN-ON VOLUME
The turn-on volume level for the system is adjustable. Since the
turn-on volume level will be the same for all zones, we suggest
setting a comfortable listening level in the room that will be used
most frequently, or in the smallest room.
While in the configuration mode, (see above) press the Set Key until
[ DEFAULT TURN ON VOLUME = 60 ] shows in the display.
Press the
+ key to increase the preset volume. Press the – key to
decrease the preset volume. The factory default setting is 60.
The volume range is from 0 to 99. Hold Set key 2 seconds to save
new turn-on volume.
To continue to the next system configuration Zone 4 Speakers, press
the Set key once. To save your settings and to exit the configuration
mode, simultaneously hold down the Band and Set keys.
[ RELEASE
BUTTONS TO CONTINUE ]
appears on the display. The ZR-4 will return
to normal operating mode.
ZONE 4 SPEAKERS
The ZR-4 MultiZone Receiver is equipped with Zone 4 pre-amplifier
output that enables the use of a separate outboard power amplifier.
The ZR-4’s built-in Zone 4 amplifier is still operational but requires
this configuration adjustment to ensure the best sound quality if
speakers are connected to it.
While in the configuration mode, (see above) press the Set Key until
[ ZONE 4 SPEAKER INSTALLED ] shows in the display.
[ ZONE 4 SPEAKER INSTALLED ] is the default setting. If speakers are
not connected to Zone 4’s built-in amplifier, press the Band key and
the display will show
[ ZONE 4 SPEAKER NOT INSTALLED ].
To return back to the first system configuration Master Slave, press
the Set key 3 times. To save your settings and to exit the configuration
mode, simultaneously hold down the Band and Set keys.
[ RELEASE
BUTTONS TO CONTINUE ]
appears on the display. The ZR-4 will return
to normal operating mode.
ERASING TUNER PRESET INFORMATION
While in configuration mode, press the Set button until the display
shows [ERASE PRESETS?]
ERASE PRESETS?
-/NO +/YES
Press + to erase all 20 tuner presets stored into the ZR-4. The
display will show [PRESETS ERASED].
PRESET S ERASED
Press the – button to exit and move to the next step without erasing
any of the presets.
To continue to the next configuration step, RESTORING FACTORY
D EFA U LTS, press the Set button.
To save the settings and exit configuration mode, simultaneously
hold down the Band and Set buttons. After the ZR-4 saves the
information, [RELEASE BUTTONS TO CONTINUE] appears on the
display. The ZR-4 will return to the normal operating mode.
RESTORING THE FACTORY DEFAULTS
While in configuration mode, press the Set button until
[FACTORY RESET] appears on the display.
FACTORY RESET
-/NO +/YES
Press + to erase all configuration data. All Master/Slave, zone
linking, paging, party mode, bass, treble, and loudness settings
will return to the factory default. The display will show [CONFIRM
ERASE].
CONFIRM ERASE
-/NO +/YES
DEFAU LT TURN ON
VOL UME = 60
DEFAU LT TURN ON
VOL UME = 55
RELEASE BUTTONS
TO CONTINUE
ZONE 4 S PEA KER
I NSTALLED
ZONE 4 S PEA KER
NOT I NSTALLED