Filter
Top Products
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373 11
INSTALLATION
1) SET THE RF MODE DIPSWITCHES (Figure 9)
2) CONNECT CAT-5 CABLE
Connection to a MultiZone receiver or a keypad uses CAT-5 cable terminated with
RJ45 connection plugs. The CAT-5 cable must be terminated using the T568A
standard wiring
(Figure 10).
3) CONNECT POWER SUPPLY PER RFG SET-UP
Based on the mode of the RFG, a Niles Power Supply maybe needed (see System
Considerations section to see if optional power supply is needed).
4) MOUNT THE RFG
(see Figure 7)
5) SET RF COMMUNICATION CHANNEL
After the RFG has been mounted and all connections made, the RF channel must
be set if the RFG is being used in a wireless keypad mode. The RF channel can be
set by accessing the installer settings mode of the keypad (please see Niles Keypad
manual for information on this menu).
Figure
9. Repeater Base Dipswitch setting
Figure 10. T568A wire termination
1 = GREEN/WHITE
2 = GREEN
3 = ORANGE/WHITE
4 = BLUE
5 = BLUE/WHITE
6 = ORANGE
7 = BROWN/WHITE
8 = BROWN
Dipswitches