Filter
Top Products
66
66
6
UNPACKING AND SETUP
Packed with your T 163 tuner preamplifier you will find:
• An AM loop antenna
• A FM ribbon-wire antenna with balun
• A removable AC cable (if you wish, any IEC-standard AC cable of suitable wattage may be substituted).
• The HTR 2 remote control with 4 (four) AAA batteries.
• The ZR 2 zone remote control with 3V CR2025 battery.
• This owner’s manual.
Save the packaging
Please save the box and all of the packaging in which your T 163 arrived. Should you move or otherwise
need to transport your tuner preamplifier, this is by far the safest container in which to do so. We’ve seen
too many otherwise perfect components damaged in transit for lack of a proper shipping carton, so please:
Save that box!
Choose a location that is well ventilated (with at least several inches to both sides and behind), and that will
provide a clear line of sight, within 25 feet/8 meters, between the tuner preamplifier’s front panel and your
primary listening/viewing position—this will ensure reliable infrared remote control communications. The T
163 generates a modest amount of heat, but nothing that should trouble adjacent components. It is
perfectly possible to stack the T 163 atop other components, but the reverse usually should be avoided. It
is especially important that sufficient ventilation be provided; if you are contemplating locating the T 163
within a cabinet or other furniture, consult your NAD audio/video specialist for advice on providing adequate
airflow.
CHOOSING A LOCACHOOSING A LOCA
CHOOSING A LOCACHOOSING A LOCA
CHOOSING A LOCA
TIONTION
TIONTION
TION
WHAWHA
WHAWHA
WHA
T’S IN THE BOXT’S IN THE BOX
T’S IN THE BOXT’S IN THE BOX
T’S IN THE BOX
1 Rotate the outer frame of the antenna.
2 Insert the bottom edge of the outer frame into the groove on the stand.
3 Extend the antenna cord.
ASSEMBLING THE AM LOOP ANTENNAASSEMBLING THE AM LOOP ANTENNA
ASSEMBLING THE AM LOOP ANTENNAASSEMBLING THE AM LOOP ANTENNA
ASSEMBLING THE AM LOOP ANTENNA
CONNECTING AM ANTENNA
Insert into the groove