Filter
Top Products
3
Sound Pressure Level (SPL): 92 dB
Total Continuous Power: 46 Watts RMS
• Front Speakers: 11 Watts/channel @ 4 ohms
@ 10% THD @ 180 Hz – 20 kHz
2 Channels Loaded
• Subwoofer: 24 Watts @ 8 ohms
@ 10% THD @ 32 Hz – 180 Hz
Single Channel Loaded
System Response: 32 Hz – 20 kHz (-10 dB)
Signal to Noise Ratio
@ 1 kHz input: > 85 dB
Drivers (per satellite): One 40mm mid-range driver and
one 18mm high-end tweeter
Subwoofer: Two 5.25" long-throw woofers
in isobaric configuration
System Specifications*
Altec Lansing’s superior sound comes from our patented Dynamic EQ technology, which utilizes custom-built, high-fidelity drivers, state-of-the-art equalization circuitry,
and a harmonious mix of the following specifications:
*Power rating conforms to FTC Amplifier Rule #16 C.F.R. Part 432.
No LEDs are lit.
Power isn’
t tur
ned on.
AC power cor
d isn’
t connected to the wall outlet.
Sur
ge pr
otector (if used) isn’
t power
ed on.
Wall outlet not functioning.
Turn on the speaker system by pressing the button on the control pod or
wir
eless r
emote. An LED will light on the contr
ol pod when the power is ON.
After all other connections are made, plug the AC power cord (on the back of
subwoofer) into a wall outlet.
If the AC power cord is plugged into a surge protector, make sure the surge
protector is switched on.
Plug another device into the wall outlet (same jack) to verify the wall outlet
is working.
Troubleshooting
Sy
mpt
om Possible Problem Solution
Loudness
T
he loudness function contours the high and low frequencies to maximize the
perceived audio. Press the “LOUDNESS” button on the control pod or “LOUD”
b
utton on the wireless remote to turn it on. Press either button again to turn
i
t off.
SFX Technology™
Sound Field Xpander™ technology allows your speaker system to deliver a wider
s
tereo image for bigger sound at the touch of a button. Press the “SFX” button
on the control pod or wireless remote to turn it on. Press it again to turn it off.
Note: This feature does not work when using headphones.
Stand-By/Mute
T
o mute the speaker system, press the button located on the control pod or
wireless remote. The LED on the control pod will turn off. To un-mute, perform
e
ither command again.
N
ote: While in stand-by or mute mode, the system continues to receive power. To
completely shut down the unit unplug the unit from the wall.
Reset
T
he button marked with the word “reset” on the wireless remote restores
volume, bass, treble, loudness and SFX controls to original factory settings.
IPod/MP3 Player Jack
T
he iPod or MP3 player jack is located on the side of the control pod. Use it to
c
onnect any audio source that has a stereo 3.5mm plug (i.e. headphone style
plug.)
C
aution: Make sure the audio source features a line-out jack. This will ensure that
the output is not amplified. Check the owner’s manual for your audio device for
more information.
Headphones
T
he headphone jack is located on the side of the control pod. Use it to connect
any stereo headphones with a 3.5mm plug.
N
ote: When headphones are connected, the speaker system is muted.