Filter
Top Products
19
Step 7 Video Outlet (Unswitched) Hookup
A)
Attach a Monster Power ID label to each component‘s power cord
before
you plug it into
the appropriate PowerCenter outlet.
B) A/V RECEIVER: Plug the A/V Receiver’s power cord into the corresponding A/V Receiver outlet.
C) TV: Plug your TV’s power cord into the corresponding TV outlet.
UNSWITCHEDUNSWITCHED
DIGITDIGITALAL
FILFILTER FUSETER FUSE
GROUNDGROUND
Designed in U.S.A.Designed in U.S.A.
ManufacturedManufactured
in Tin Taiwanaiwan
5A SLOW BLOW5A SLOW BLOW
5 x 20 mm5 x 20 mm
UNSWITCHEDUNSWITCHED UNSWITCHEDUNSWITCHED SWITCHEDSWITCHED TIMEDTIMED
ININ
ININ OUTOUT
ININ
PHONEPHONE
BREAKER 15ABREAKER 15A
PRESS TO RESETPRESS TO RESET
1800W 1800W
MAX TOTMAX TOTALAL
OUT 1OUT 1
OUT 2OUT 2
ININ OUTOUT
OUTOUT
NORMALNORMAL
REMOTEREMOTE
AC IN 110V 0.3AAC IN 110V 0.3A
DC IN 9~12V 300MADC IN 9~12V 300MA
CABLE TVCABLE TV
SASATELLITETELLITE
ANTENNAANTENNA
IMPORTANT NOTE:
The component-to-component noise filter featured in this group of outlets is designed
to deliver optimum performance within a power rating of no more than 1800 watts (15 amps max contin-
uous). The filter's performance will be degraded if the optimum peak power capacity is exceeded. To avoid
this, do not plug any high current components into this section (Ultra high current amplifiers or A/V
receivers should be plugged into the high power audio filter section–see page 17). We recommend
predetermining the total watts of all components plugged into this filter section before plugging in any
components. To do this, look on the rear panel of your components and find the wattage rating. Add up
the wattage for all components to be plugged into these outlets. They should not exceed 1800 watts.
NOTE: The maximum wattage rating of the entire HTS3000 is 1800 watts, therefore, you cannot ”use up”
all 1800 watts in this filter section and still connect additional additional components to the other filter
sections, which would exceed the HTS3000 maximum wattage rating.