17
Step 5 High Current Audio Outlet (Switched/Timed) Hookup
A.)
Attach a Monster Power ID label to each component‘s power cord before you plug it into
the appropriate PowerCenter outlet.
A) MAIN AMP: Plug your Main Amp’s power cord into the corresponding Main Amp outlet.
B) SURROUND AMP: Plug your dedicated Surround Amp into the corresponding Surround Amp outlet.
IMPORTANT NOTE:
The component-to-component noise filter featured in this group of outlets is designed
to deliver optimum performance within a power rating of no more than 1800 watts continuous (15 amps
max continuous). These outlets are specifically designed to withstand a peak current draw of 50 amps max.
The filter's performance will be degraded if the optimum peak power capacity is exceeded. We recommend
predetermining the total watts of all components plugged into this filter section before plugging in any
components. To do this, look on the rear panel of your components and find the wattage rating. Add up
the wattage for all components to be plugged into these outlets. They should not exceed 1800 watts.
NOTE: The maximum wattage rating of the entire HTS3000 is 1800 watts, therefore, you cannot ”use up”
all 1800 watts in this filter section and still connect additional additional components to the other filter
sections which would exceed the HTS3000 maximum wattage rating.
UNSWITCHED
DIGITAL
FILTER FUSE
GROUND
Designed in U.S.A.
Manufactured
in Taiwan
5A SLOW BLOW
5 x 20 mm
UNSWITCHED UNSWITCHED SWITCHED TIMED
IN
IN OUT
IN
PHONE
BREAKER 15A
PRESS TO RESET
1800W
MAX TOTAL
OUT 1
OUT 2
IN OUT
OUT
NORMAL
REMOTE
AC IN 110V 0.3A
DC IN 9~12V 300MA
CABLE TV
SATELLITE
ANTENNA