18
Step 6 Low Noise and Audio Outlet (Switched) Hookup
A) Attach a Monster PowerID label to each component‘s power cord before you plug it into the appropriate
PowerCenter outlet.
B) PREAMP: Plug the preamp’s power cord into the corresponding PREAMP outlet.
C) TAPE: Plug your Tape deck’s power cord into the corresponding TAPE outlet.
IMPORTANT NOTE:
The component-to-component noise filter featured in this group of outlets is designed
to deliver optimum performance within a power rating of no more than 1200 watts (10 amps max continuous).
The filter's performance will be degraded if the optimum peak power capacity is exceeded. We recom-
mend predetermining the total watts of all components plugged into this filter section before plugging in
any components. To do this, look on the rear panel of your components and find the wattage rating.
Add up wattage for all components to be plugged into these outlets. They should not exceed 1200 watts.
UNSWITCHED
DIGITAL
FILTER FUSE
GROUND
Designed in U.S.A.
Manufactured
in Taiwan
5A SLOW BLOW
5 x 20 mm
UNSWITCHED UNSWITCHED SWITCHED TIMED
IN
IN OUT
IN
PHONE
BREAKER 15A
PRESS TO RESET
1800W
MAX TOTAL
OUT 1
OUT 2
IN OUT
OUT
NORMAL
REMOTE
AC IN 110V 0.3A
DC IN 9~12V 300MA
CABLE TV
SATELLITE
ANTENNA