Filter
Top Products
GUIDE TO INSTALLATION AND OPERATION
24 | JAZZ-800
Format / Frame-rate Select – Section 3
480/576 (Button) – If an input channel is selected, on first press the system sets the selected input to 480
lines. On second press, the input is set to 576 lines. If one of the output channels is selected, on first press
the selected output is set to 480 lines. On the second press, the output is set to 576 lines. After selecting,
press the ROTARY ENCODER to accept.
Button Color State Mode
Comments
Green Solid Update
Available but not selected
Cyan Solid Active
Shows association with currently selected input or output
Blue Solid All
Shows the state of the currently selected input or output
Blue Flashing Update NEW source or destination selected – Press the ROTARY
ENCODER to confirm
720 (Button) – Sets the line rate of the currently selected input or output to 720. After selecting, press the
ROTARY ENCODER to accept.
Button Color State Mode
Comments
Green Solid Update
Available but not selected
Cyan Solid Active
Shows association with currently selected input or output
Blue Solid All
Shows the state of the currently selected input or output
Blue Flashing Update NEW source or destination selected – Press the ROTARY
ENCODER to confirm
1080 (Button) - Sets the line rate of the currently selected input or output to 1080. After selecting, press the
ROTARY ENCODER to accept.
Button Color State Mode
Comments
Green Solid Update
Available but not selected
Cyan Solid Active
Shows association with currently selected input or output
Blue Solid All
Shows the state of the currently selected input or output
Blue Flashing Update NEW source or destination selected – Press the ROTARY
ENCODER to confirm
59.94 (Button) - Sets the frame rate of the currently selected input or output to 59.94Hz. After selecting,
press the ROTARY ENCODER to accept.
Button Color State Mode
Comments
Green Solid Update
Available but not selected
Cyan Solid Active
Shows association with currently selected input or output
Blue Solid All
Shows the state of the currently selected input or output
Blue Flashing Update NEW source or destination selected – Press the ROTARY
ENCODER to confirm