Filter
Top Products
GUIDE TO INSTALLATION AND OPERATION
10 | JAZZ-800
Attaching the Control Panel
5. On the rear of the Control Panel, locate the multi-pin connector and the three ball-pin connectors.
6. On the front of the JAZZ-800 chassis, locate the multi-pin connector and the three ball-pin mating
connectors.
7. Orient the Control Panel so that the multi-pin connector and the ball-pin connectors of the Control Panel
line up with the respective mates on the front of the JAZZ-800 chassis.
8. Slide the Control Panel towards the chassis until the multi-pin connector and ball-pins begin to mate with
the Chassis.
9. Press firmly on the Control Panel until the multi-pin connector and ball-pins are fully seated.