Filter
Top Products
4
General Information and Cable Information
General Information
Caution: To prevent possible damage to the turntable platter
bearing, do not move the MT10 Precision Turntable
with the platter installed.
1. For additional connection information, refer to the
owner’s manual(s) for any component(s) connected to
the MT10 Precision Turntable.
2. The MT10 Precision Turntable comes with the McIn-
tosh MCC10 High Performance Moving Coil Cartridge
preinstalled.
3. It is recommended the Professionals at your McIntosh
Dealer, who are skilled in all aspects of Turntables and
Phono Cartridges, install the MT10 Precision Turntable
and any associated audio equipment.
4. For optium performance, the setup and adjustment
of the MT10 Precision Turntable requires special test
recordings and test/measument equipment. Contact
your McIntosh Dealer for additional information and
assistance.
Power Control Connector
The MT10 Power Control Input/Output Jacks receive/send
Power On/Off Signals when connected to other McIntosh
Components. A 1/8 inch stereo mini
phone plug is used for connection to
the Power Control Input/Output on the
MT10.
Note: The Data ad Power Control Con-
necting Cable is available from the
McIntosh Parts Department:
Data and Power Control Cable Part No. 170-202
Six foot, shielded 2 conductor, with 1/8 inch stereo mini
phone plugs on each end.
Tonearm Headshell Wiring
Refer to the following list of wire colors in the headshell
for installing the cartridge into the Headshell:
Cartridge Connections Headshell Wire Color
Left Channel (+) White
Left Channel (-) Blue
Right Channel (+) Red
Right Channel (-) Green
McIntosh MCC10 Cartridge Connections
Refer to the following illustration when connecting the
McIntosh Cartridge in the Headshell:
Connector and Cable Information
Power
Control
Ground
N/C
RL
E
L
E
R
Right Channel (-)
Right Channel (+)
Left Channel (-)
Left Channel (+)
Rear View of McIntosh MCC10 Cartridge