Filter
Top Products
14
2. Release the Tone Arm from the Tone Arm Holder. Refer
to figure
54.
3. Position
the Tone
Arm
over the
desired
spot of
the Pho-
tograph
record.
4. Pull on
the top part of the Tone Arm Lift Lever towards the
front of the turntable to begin playback.
Power Selection
Rotate the POWER Switch to select the Turntable opera
-
tion mode you desire. Refer to figure 50.
Power Off - The Front Panel and Turnta-
ble Platter lights are turned
Off. There is no Turntable
Platter rotation.
Standby - The Front Panel and Turn-
table Platter will illuminate
when the McIntosh Preamplifer or A/V
Control Center is turned On. There is no
Turntable Platter rotation.
Note: There must be a power control con-
nection between the MT10 and the
McIntosh Preamplifier or A/V Con-
trol Center, in order for the Standby
Mode to function.
On - The Front Panel and Turntable Platter lights
are turned On. The Turntable Platter will
rotate at the selected speed.
Speed Selection
Rotate the SPEED Switch to select the playback speed (33-
1/3 rpm, 45 rpm or 78 rpm) of the phono
-
graph record to be played. Refer to figure
51.
The Front Panel Platter Speed Meter
indicates the actual speed of the Turntable
Platter during playback of the recording.
Refer to figure 52.
Tone Arm Lift
The McIntosh MT10 Precision Turntable has a built-in
manual Tone Arm Lift Mechanism for safe placement and
removal of the cartridge stylus on the photograph record.
Perform the following steps:
1. Push on the top part of the Tone Arm Lift Lever to-
wards
the rear
of the
turn-
table.
Refer to
figure
53.
How to Operate the Turntable
How to Operate the Turntable
Figure 50
Figure 51
Figure 52
Figure 53
Tone Arm Lift Lever
Figure 54
Tone Arm Holder