Filter
Top Products
57
5. When a CD is playing, the sound "skips."
✓ The CD is severely scratched or dirty.
✓ The Nº390S is on an unstable surface or is too close to
your speakers.
6. The linked functions don’t work.
✓ The Link cable is disconnected, or is connected incorrectly.
Check your Link connections.
✓ The Link options are turned off.
✓ The preamplifier is not aliased (renamed) for the Nº39.
✓ The processor (if one is being used) does not have one of
its inputs tied to the Nº390S.
✓ Try turning off/disconnecting AC power from both the
preamplifier and the Nº390S. After several seconds, restore
AC power to the preamplifier, then turn on the Nº390S’s
main power switch. Never operate the main power switch
without first making sure that power is turned off to your
receiver, integrated amplifier, or preamplifier/power amplifier.
✓ Some associated Mark Levinson components may have
older versions of the system software that do not fully
support all Linked functions. Contact your Mark Levinson
dealer with the model and serial numbers of your Mark
Levinson components. If needed, new EPROMs will be
provided at no charge.
7. The Remote Control doesn’t operate the Nº390S.
✓ The Remote Control is at the wrong angle relative to the
Nº390S, and the Nº390S can’t receive the signal.
✓ The sensor window on the front panel of the Nº390S is
dirty or blocked.
✓ The Remote Control’s projection lens is dirty.
✓ Fluorescent lighting or sunlight is interfering with the
operation of the Remote Control.
✓ The Remote Control’s batteries are weak and need to be
replaced.
✓ The Remote Control’s batteries are installed incorrectly.