Filter
Top Products
14
6. slave in & slave out communication ports
Provide “links” to compatible Mark Levinson preamplifiers
and power amplifiers, allowing the Nº33H and linked
preamplifiers or power amplifiers to share Link controls. Two
6-pin modular RJ-11 jacks labeled slave in and slave out are
available.
The slave in communication port can be connected to a
compatible Mark Levinson preamplifier that offers Link or
communication ports. The slave out communication
ports can be connected to a compatible Mark Levinson power
amplifier that offers Link or communication ports.
Note
Refer to “Linking” BEFORE linking the Nº33H to other Mark
Levinson components.
7. remote turn-on jacks
Provide DC trigger control. One 1/8-inch (3.5mm) mini-jack is
available to receive 5–12V DC signals from a connected compo-
nent, and one 1/8-inch mini-jack is available to pass these sig-
nals along to a connected power amplifier. The illustration
below shows tip polarity requirements.
Connect one of the remote turn-on jacks on the Nº33H to the
trigger out connector on a compatible component. Toggling
the connected component between on and standby will toggle
the Nº33H into and out of standby.
Connect the other remote turn-on jack on the Nº33H to the
trigger in connector on a compatible power amplifier. The
Nº33H will pass DC signals along to the connected power
amplifier, creating a “daisy-chain” of trigger control.
Note
The Nº33H must be powered on with the ~ac mains relay
switch to respond to remote trigger commands.
5 to 12V, positive tip polarity