Filter
Top Products
12
ENGLISH
LFE ATT (LFE attenuater)
Select the output level of the LFE signal included in the Dolby Digital
signal or the DTS signal. Select 0dB, -10 dB or OFF with or
button.
The level is ordinarily set to 0 dB. When use DTS Music source, LFE
level is set to -10 dB.
DIG IN (Digital input)
Four digital inputs can be assigned for the desired source.
Use this menu to determine which source is connected to which input.
Example;
When the digital output of a DVD player is connected to Digital 4 (input
jack) of the SR4200;
1. Select “DIG IN” with cursor buttons or and press the OK or
button.
2. Select “DIGITAL4” with cursor buttons or and press the OK or
button.
3. Select “D4/DVD” with cursor buttons or and press the OK or
button.
4. If you desire to continue the next setup, press the OK or button
on NEXT-SETUP.
If you desire to exit from menu system, press the MENU OFF
button on EXIT.
Notes:
The TUNER is assigned to the analog input, and are prevented
from selecting any digital input.
While the DTS-LD or DTS-CD is playing, this setup is not available,
this is to avoid noise being generated from the analog input. Stop
the LD or CD playback to setup.
The SR4200 does not switch from digital input to analog input or
vice versa automatically.
In the event that both digital and analog inputs are connected to
SR4200, if you desire to switch to an analog input temporarily, you
can switch by pressing the A/D button y.
TEST MODE
When you press the T.TONE ¤1, the test tone will be cycled through in
a circular pattern which is FL (front left) → C (center) → FR (front right)
→ RS (right surround ) → LS (left surround) → SW (subwoofer) → FL
→ ... 3 seconds for each channel.