Filter
Top Products
10
ENGLISH
CONNECTING VIDEO COMPONENTS
IN
PHONO
ININ OUTIN OUT
DSSAUX
VIDEO
CONTRO
L
REMOTE
GND
VCR
IN
O
U
L
IN
OUT
INOUT OUT ININ
IN
OUTIN
(CD-R) (TAPE)
AUXCD DSS PREDVDRECORDER 2 MAINVCRRECORDER 1
I
N
DVD
AUDIO
R
MONITOR
ININ
AM
FM
(
75
)
GND
ANTENNA
VIDEO
IN
CVBS
LR
AUDIO
OUT
VIDEO
OUT
LR
AUDIO
OUT
AUDIO
IN
LR
VIDEO
OUT IN
LR
AUDIO
OUT
VIDEO
OUT
L RL R
LR
L R L R
LR
LR
L R
L R
LR
AUDIO
ININ OUTIN
DSSAUX DVD VCR
IN
ININ OUTIN
DSS VCRDVD
MONITOR
VIDEO
OUT
OUTOUT
LVIDEO R
VCR
Monitor
DVD player
Satellite tuner
VIDEO camera etc..
Notes:
• Insert all plugs and connectors securely. Incomplete connections will result in the generation of noise.
• Be sure to connect the left and right channels properly.
Red connectors are used for the R (right) channel, and white connectors are used for L (left) channel.
• Be sure to connect input and output of video signal properly.
CONNECTING THE REMOTE CONTROL JACKS
IN
PHONO
ININ OUTIN OUT
DSSAUX
VIDEO
CONTROL
REMOTE
GND
VCR
IN
OUT
L
IN
OUT
INOUT OUT ININ
IN
OUTIN
(CD-R) (TAPE)
AUXCD DSS PREDVDRECORDER 2 MAINVCRRECORDER 1
IN
DVD
AUDIO
R
MONITOR
ININ
AM
FM
(
75
)
GND
ANTENNA
OUT
REMOTE
CONTROL
REMOTE
CONTROL
REMOTE
CONTROL
IN
OUT
IN
OUT
IN
OUT
EXTERNAL INTERNAL
EXTERNAL INTERNAL
EXTERNAL INTERNAL
OPEN/CLOSE
FL OFFVIRTUAL
STANDBY
POWER ON/STANDBY
DVD PLAYER DV4600
CD player
CD recorder
DVD player
q
You can control other Marantz products through
this unit with the remote control by connecting the
REMOTE CONTROL terminals on each unit.
The signal transmitted from the remote control is
received by the remote sensor on this unit. Then the
signal is sent to the connected device through this
terminal. Therefore you only need to aim the remote
at one unit. Also, if a Marantz power amplifi er (some
models exclu
ded) is connected to one of these
terminals, the power amplifier’s, power switch is
synchronized with this unit’s power switch.
Set the REMOTE CONTROL SWITCH on the units,
other than the main unit to EXT.(EXTERNAL) for this
feature.
w
Whenever external infrared sensors or similar
devices are connected to RC-5 IN of the SR4021,
be sure to always disable operation of the infrared
sensor on the main unit by using the following
procedure.
1.
Hold down the SLEEP button and DIMMER
button on the front panel at the same time for 3
seconds.
2.
The setting “IR=ON” is shown on the FL
DISPLAY.
3.
Turn the MULTI JOG knob to change this to
“IR=OFF”.
4.
Press the MEMORY button. Once this setting
is made, the infrared sensor on the main unit is
disabled.
Note:
Be sure to set to “IR=ON” when external infrared
sensors or similar devices are not connected.
Otherwise, the main unit will be unable to receive
remote control commands.
5.
To restore the original setting, perform steps 1
to 4 to set to “IR=ON”.