Filter
Top Products
ENGLISH
12
LCD INDICATORS (RC8001SR)
Information about currently selected source and
direct code names are displayed on the LCD.
LEARN
NAME
MACRO
USE
PAG E
123
4
A
B
C
D
E
F
G
H
I
J
A Source Name indicator
This displays the name of the selected source, such
as DVD, television, or other AV equipment (up to fi ve
characters).
B Direct Button Name indicator
This displays up to 20 types of button names for each
source. (up to six characters)
C Page indicator
This displays the current page position.
D Transmission indicator
This indicator is displayed when the remote controller
is sending a signal.
E USE indicator
This indicator is displayed under normal operation.
F Battery Level indicator
This indicator is displayed when the battery level is
low.
G TIMER indicator
This indicator is displayed when the macro timer is
set.
(7) DISP. button
Selects the display mode for the front display of the
unit.
(8) OSD button
When this button is pressed, the current setting are
displayed on the TV monitor.
(9) SLEEP (sleep timer) button
This button is used for setting the sleep timer.
Each time this button is pressed, the sleep timer
is increased by 10 minutes, in a range of 10–120
minutes.
(0) THX button
Use this button to select the THX mode.
⁄2 MEMO button
This button is used to store settings to memory or
program a source.
⁄3 CONTROL button
Thses buttons are used when operating the PLAY,
STOP, PAUSE, and other commands of a source.
Note:
• This button is unavailable for the unit.
⁄4 SOURCE button
Thses buttons are used to switch the source of your
A/V Receiver / amplifer. Each time a source button is
pressed, the remote controller changes to the source
which was pressed.
This remote controller can control 12 types of
equipment. To change the A/V Receiver / amplifi er
source, press this button twice within two seconds.
The signal is sent when it is pressed the second
time.
Note:
• Select the AMP as the source to use this remote
controller with the unit.
• The MD button does not work with the unit.
⁄5 LIGHT 1 and 2 buttons
Pressing these buttons will light up the LCD and its
buttons. This lighting time can be set. If the lighting
time is set to 0 seconds, the backlight turns on only
while this button is pressed. The operations for
LIGHT 1 and 2 are identical.
⁄6 CLEAR button
This button is used to erase the memory or program
of a source.
⁄7 MENU button
(when AMP mode is selected)
This button is used to call up the SETUP MAIN
MENU of the unit.
⁄8 PREV (Previous) button
This button is used to return to the previous channel
on the television or other device.
Note:
• This button is unavailable for the unit.
⁄9 CH (Channel) button
This is used to change channels.
¤0 CURSOR buttons
These buttons are used when controlling the cursor
of the unit, DVD, or other AV equipment.
¤1 LCD
Information about the sources and modes are shown
on the LCD.
H MACRO indicator
This indicator is displayed when the remote controller
is in macro programming mode.
I NAME indicator
This indicator is displayed when the remote controller
is in renaming mode.
J LEARN indicator
This indicator is displayed when the remote controller
is in learning mode.