Filter
Top Products
II
[,--N_A_M_E_S_A_N_D_F_U_N_C_TI_O_N_S
_O_F_PA_R_T_S
~]
I (FRONT PANEL ]
11
10
9
8 7 6 5
~-..r:::=::===I=FI-
-1;;:;:;;;;;;;;;:;;;:::::::;:;:;;;:;;;;;;;;;:=;::::::::;;;:;;:;;::::;;::::::;;;;;;;;;::::;:;;;1-
-I:;::I===J......""......."
~~
(0
=::-0
"----I,:====r-a----"'~
=!="=!
2
I=-===I-e""""\==~r41---J
CD
POWER ON/OFF Switch
This switch turns power to the unit ON and
OFF.
When
pressed, power is activated and the blue indicator
in
the
display
@ lights up. Pressing the switch again turns the
power
OFF.
en
Display
Indicate the selected input source, volume level, and
setting status.
® Infrared Receptor Window
This receptor window receives control signals sent from
the included remote controller.
® VOLUME Knob
This knob is for setting the volume. The volume level
is
displayed on the display @. When turned slowly, the
volume can be fine-adjusted
in
O.5dB
steps, whereas when
turned rapidly, the volume level changes greatly.
® PRE OUT Button
This buttons turns output from the PRE OUT jack and
BALANCED PREOUT jack on the rear panel ON and
OFF.
When using just the headphones, switch this button
OFF.
® PHONO MC Button
This button switches the Phono equalizer amplifiersetting
between MC and MM. Set the phono equalizer amplifier
according to the type of cartridge you use.
6
(J)
ATT.
Button
This button attenuates the volume with one press of the
button. For instructions on
How
to Set the Attenuation
Level,
see page. 21.
® Illumination Lamp
The illumination lamp casts a blue light over the switches
and buttons. It can be turned ON and
OFF
with the
DISPLAY button. For instructions on
HOWTO
OPERATE
THE
SIDE ILLUMINATION, see page. 24.
® DISPLAY Button
This button turnsthe displayand side illumination ON and
OFF.
For instructions on HOWTO OPERATE
THE
SIDE
ILLUMINATION,
see page. 24.
@ TONE Button
This button turns the bass and treble tone control ON and
OFF.
For instructions on
How
to
Trim Bass and Treble,
see page. 23. If pressed and held for 2 seconds or longer,
this button switches the subsonic filter ON/OFF. Fordetails
on
SUBSONIC FILTER, see page 21.
@ PHONES OUT Button
This button switches the headphone jack output signal
ON/OFF. Set this to OFF when not
in
use.
@ INPUT SELECTOR Knob
This knob is for selecting the input source to use in
playback and recording. The selected input source is
displayed in the display
@.
@ PHONES Jack
This jack is for connecting headphones with a standard
stereo plug.