Filter
Top Products
4
Operating Voltage
The TDAI 2200 is available in two versions: one for 115V mains voltage and another for 230V mains volt-
age.
Check the label on the TDAI 2200 rear panel and verify you have the version with the proper voltage for
your area.
The 115V version requires a mains voltage of 110V-120V at 50-60Hz with a current rating of 8A.
The 230V version requires a mains voltage of 220V-240V at 50-60Hz with a current rating of 4A.
The mains voltage setting for your TDAI 2200 can be changed ONLY BY A QUALIFIED ENGINEER.
Connect the power input only to the AC source printed on the label. The warranty
will not cover any damage caused by connecting to the wrong type of AC mains.
The TDAI 2200 has three power modes:
OFF 1.
No circuitry is powered.
STANDBY 2.
The mains transformer and amplifi er section are powered off - only the remote control input and the mi-
croprocessor is powered, so the unit can be powered up using the remote control ‘STANDBY’ button.
ON 3.
All circuits active.
Unpacking the TDAI 2200
Carefully remove the unit and accessory kit from the carton, visually check for shipping damage.
Contact both the shipper and your Lyngdorf Audio representative immediately if the unit bears any sign
of damage from mishandeling. All Lyngdorf Audio equipment is carefully inspected before leaving our
factory.
Keep shipping carton and packing material for future use or in the unlikely event that
the unit needs servicing. If this unit is shipped without the original packing, damage
could occur and void the warranty.
Serial Number Registration
Please record the serial number of your amplifi er here for future reference. The serial number is printed
on the label on the TDAI 2200 rear panel. You will need this serial number, should you ever require
service for your TDAI 2200 amplifi er.
TDAI 2200 serial number: _____________________