Filter
Top Products
25
Advanced setup
The sub menus accessible in the Advanced menu are:
Communication
The sub menus accessible in the Communication menu are:
Comm Address
The Communication Address setting identifi es the TDAI 2200’s to the PC interface or other Lyngdorf
products. In master mode the amplifi er setting is normally 1, and the addresses 2-99 can be used for
individual slave amplifi ers, but nothing is restricted. The PC software must know the address of the TDAI
2200 in order to communicate with it.
Comm Speed
The Communication Speed setting is the RS232 Link interface speed. The default setting is 57600 baud.
With different PC’s and different lengths of cables the settings can be changed to 9600 or 115200 baud.
If a multi-amplifi er set-up is installed with Master/Slave communication, a smaller delay can be observed
when using higher speeds.
Master/Slave
As default a TDAI 2200 is set as a Slave. The Master setting should be used if you are using two TDAI
2200, e.g. for bi-amping or if using one to drive the main loudspeakers and one to drive the Lyngdorf
Audio cornerwoofer(s) or the subwoofer(s). When set as a Master the fi rst TDAI will control the second
TDAI (the Slave), e.g. when adjusting the volume control and when switching on and off.
Advanced setup
Line Out
Communication
Master/Slave
Routing
Crossover freq.
Filter Type
Delay
Trigger setup
Remote Control
Software versions
Factory Reset
Communication
Comm Address Comm Speed
Master/Slave