Filter
Top Products
32
Connectors
Mains Connector
Mains voltage to the TDAI 2200 is applied via an IEC320 type connector. The supplied cable with safety
ground should be used to connect the TDAI 2200 to a mains outlet.
Connect the power input only to the AC source printed on the label. The warranty
will not cover any damage caused by connecting to the wrong type of AC mains.
Always disconnect the TDAI 2200 from the mains before changing any connections
to its inputs or outputs.
Loudspeaker Connectors
The TDAI 2200´s loudspeaker connectors accept bare wire ends up to 5 mm in diameter. Connect the
wires from each loudspeaker to each channel’s + and – terminals. Do not make any other connections to
the output terminals. Ensure the loudspeaker cable is inserted into the slot in the loudspeaker terminal,
and the terminal is tightened fi rmly.
Always disconnect the TDAI 2200 from the mains before changing any connections
to its inputs or outputs.
Make sure that no conductive part of the loudspeaker wiring is accessible. Do not
connect loudspeakers with uninsulated terminals.
When the TDAI 2200 is operating, there is up to 35V DC on its output terminals with reference to
ground.
Do not connect the output from the amplifi er to any other amplifi er’s output or
any other voltage source. Do not attempt to operate the amplifi er in bridged mono
mode.
Trigger Connector
The TDAI 2200 is equipped with a TRIGGER OUT 3.5mm mono jack connector. The Trigger signal is a
12V short circuit-protected output signal for powering up external equipment when the TDAI 2200 is on,
e.g. remotely connected SDA 2175 power amplifi ers or active subwoofers.