Filter
Top Products
Setup
SLEEP TIMEOUT
Set the time elapsed before the front panel display enters sleep mode (i.e. shows three
dots) after a key on the front panel or handset is pressed.
Options:
NNEEVVEERR SSLLEEEEPP,, IIMMMMEEDDIIAATTEE,, 3300 SSEECC..,, 55 MMIINNSS..
Default setting:
NNEEVVEERR SSLLEEEEPP
STARTUP SOURCE
Set the source the unit selects when brought out of standby.
Options:
LLAASSTT UUSSEEDD,, NNOONNEE,, ((aannyy ooff tthhee ssoouurrccee iinnppuuttss))
Default setting:
LLAASSTT UUSSEEDD
STANDBY RECORD FROM
You can record from a source component to a recording device through the EXOTIK,
even if the EXOTIK is in standby mode.
Set which source configuration you want the EXOTIK to select when it is in standby.
Options:
LLAASSTT UUSSEEDD,, NNOONNEE,, ((aannyy ooff tthhee ssoouurrccee iinnppuuttss)),, AASS KKNNEEKKTT**
Default setting:
LLAASSTT UUSSEEDD
KNEKT
If your EXOTIK is installed in a Linn KNEKT multi-room system, select the appropriate
setting. If your EXOTIK is not installed in a KNEKT system, select
NNOONNEE
.
Options:
NNOONNEE,, MMAAIINN RROOOOMM,, LLOOCCAALL RROOOOMM,, IINNTTEERRSSEEKKTT
Default setting:
NNOONNEE
ACCESSORY SOCKET
Define the use of the accessory (ACC/RCU) socket on the back panel.
Options:
RRCCUU**
(KNEKT Room Control Unit)
,, IIRR
(Infrared Repeater)
Default setting:
RRCCUU
*For use with Linn KNEKT systems.
PRODUCT IR
Enable or disable the infrared receiver on the front of the unit.
Options:
EENNAABBLLEE,, DDIISSAABBLLEE
Default setting:
EENNAABBLLEE
RS232 Setup
Accesses the RS232 SETUP sub-menu.
The RS232 Setup sub-menu is for use if the EXOTIK is communicating with other RS232
enabled products (e.g. a third-party controller).
BAUD RATE
Set the baud rate to suit the RS232 protocol being used.
Range:
11220000 ttoo 223300440000
(11 settings)
Default setting:
99660000
PARITY
Set parity to suit the RS232 protocol being used.
Options:
EEVVEENN,, OODDDD
Default setting:
EEVVEENN
DATA BITS
Set the data bits to suit the RS232 protocol being used.
Options:
77,, 88
Default setting:
77
STOP BITS
Set the stop bits to suit the RS232 protocol being used.
Options:
11,, 22
Default setting:
11
13
English
EXOTIK PRE-AMPLIFIER
Owner’s Manual