Filter
Top Products
Using the setup menus
TToo aacccceessss tthhee sseettuupp mmeennuuss::
Either
●
Press
SSEETTUUPP
on the handset.
or
●
Hold
SSEELLEECCTT
on the front panel until MAIN MENU / SPEAKER SETUP is shown on
the display.
TToo aacccceessss tthhee iinnssttaalllleerr mmeennuu::
●
Hold
SSEETTUUPP
on the handset or
SSEELLEECCTT
on the front panel until INSTALLER MENU
is shown on the display (approximately 5 seconds).
TToo nnaavviiggaattee tthhrroouugghh tthhee mmeennuuss aanndd ooppttiioonnss::
●
Use the
/
keys on the handset or front panel. Arrows on the display indicate
which key(s) can be used.
TToo mmaakkee aa sseelleeccttiioonn::
●
Press
‘‘eenntteerr’’
on the handset, or
SSEELLEECCTT
on the front panel.
TToo eexxiitt ffrroomm tthhee sseettuupp mmeennuuss::
●
Press
SSEETTUUPP
on the handset (if changes have been made you will be prompted to
save or not save the changes).
Setup
English
EXOTIK PRE-AMPLIFIER
Owner’s Manual
7
Speaker setup
SIZE
Accesses the SPEAKER SIZE sub-menu.
For all loudspeakers in your system (except a subwoofer) you must inform the
EXOTIK whether the speakers are LARGE or SMALL. These settings refer to the
frequency response of the loudspeakers, not to their physical size.
Standard EXOTIK
For loudspeakers that operate below 100 Hz, select
LLAARRGGEE
.
For loudspeakers that do not operate below 100 Hz, select
SSMMAALLLL
. Frequencies in
the audio signal that are below 100 Hz will be routed to a subwoofer, if present, or
any LARGE loudspeakers, if not.
SMALL FREQUENCY (EXOTIK+DA)
Select the operating frequency that your limited bass response (SMALL)
loudspeakers operate above. Frequencies in the audio signal that are below the
selected option will be routed to a subwoofer, if present, or any full-range
loudspeakers (LARGE), if not.
Options:
4400 HHzz,, 6600 HHzz,, 8800 HHzz,, 110000 HHzz,, 112200 HHzz
Default setting:
8800 HHzz
FRONT*
Large front speakers (full-range frequency response), set to
LLAARRGGEE
.
Small front speakers (limited bass response), set to
SSMMAALLLL
.
Default setting:
LLAARRGGEE
*For two-channel systems, use the FRONT item and set CENTRE, SURROUND and
SURROUND BACK to
NNOONNEE
.