Filter
Top Products
There are differences in the method of performing loudspeaker calibration on a standard
EXOTIK and an EXOTIK+DA:
Standard EXOTIK
You will need a test disc that contains a tone signal for each loudspeaker in your system.
Your specialist Linn retailer may be able to supply you with a suitable disc.
To perform speaker calibration:
●
Add a Linn UNIDISK player to the EXOTIK by following the setup instructions on
page 16.
●
Exit setup and change source to ‘UNIDISK’.
●
Re-enter setup and return to the SPEAKER CALIBRATION sub-menu.
●
Play the tracks on the test disc for speaker calibration while selecting the
appropriate loudspeakers from the EXOTIK’s menu.
●
If the tone signal coming from a particular loudspeaker is louder or quieter
than from the other loudspeakers, use the
/
keys on the handset to
trim the volume as required.
EXOTIK+DA
To perform speaker calibration:
●
Select
CCAALLIIBBRRAATTIIOONN LLEEVVEELL
. Adjust the calibration level so that the signal you
hear is at a comfortable listening level (or reaches a preset level on an SPL
meter).
●
Select
SSTTAARRTT
. The signal will move round the loudspeakers in your system in
a clockwise direction and will be indicated on the display.
●
When the signal reaches a loudspeaker which is louder or quieter than the
other loudspeakers, use the
/
keys on the handset to trim the volume
as required. A few seconds after the or key has been released the
signal will continue its clockwise direction.
●
To exit loudspeaker calibration, press
SSEETTUUPP
on the handset or
SSEELLEECCTT
on
the front panel.
Range:
--1155 ddBB ttoo 1155 ddBB
(in 0.5 steps)
Default setting:
00 ddBB
Select
SSAAVVEE
to save your changes and return to the SPEAKER SETUP menu.
Select
BBAACCKK
to return to the SPEAKER SETUP menu without saving changes.
Select
EEXXIITT
to leave setup (if changes have been made and SAVE has not been
selected, you will be prompted to save or not save the changes).
Select
BBAACCKK
to return to the MAIN MENU.
Select
EEXXIITT
to leave Setup.
Source setup
Select the back panel input you wish to use with your source component.
Please complete the source setup procedure for each source component you are
connecting to your EXOTIK.
Options:
AANNAALLOOGG GGRROOUUPP,, AANNAALLOOGG 11 ttoo 66,, SSPPDDIIFF 11 ttoo 33**,, TTOOSS ((TTOOSSLLIINNKK)) 11 ttoo 33**,,
KKNNEEKKTT..
Notes:
If you are not using a UNIDISK player and wish to use the input(s) assigned to a UNIDISK
player, enter the UNIDISK SOURCE menu and set ANALOG SOURCE and DIGITAL
SOURCE* to
NNOONNEE
(see page 14).
The ANALOG GROUP uses the ANALOG 1, 2 and 3 inputs, therefore if a source is
assigned to ANALOG GROUP you cannot also assign a source to ANALOG 1, 2 or 3.
Conversely, if a source is assigned to ANALOG 1, 2 or 3, you cannot assign a source to
ANALOG GROUP.
*EXOTIK+DA
Setup
English
EXOTIK PRE-AMPLIFIER
Owner’s Manual
9