LG Electronics AR702BR Stereo Receiver User Manual


 
24
2. Press AUTO CAL..
"Audyssey 2EQ", “AUTO CAL. : START” and
“AUTO CAL. : 1ST-P” flash in the display window
in turn.
3. Press ENTER.
- “FL TESTING..” appears in the display window.
- The speaker setup function is automatically
measured in the first position from each speaker.
FL TESTING..C TESTING..FR TESTING..
SR TESTING..SC TESTING..SL TESTING..
SW TESTING..
- After completed, the “B 2nd-POS CAL.”
appears in the display window.
Notes
If each speaker is not connected, “CONNECT
SPK” flashes in the display window.
If the speaker setup microphone is not
connected, “CONNECT MIC” appears in the
display window.
4. Measure a second position (recommended) or
calculate results for first position only.
Select “B 2nd-POS CAL.” or “2nd-POS BCAL.”
by pressing b/B.
B 2nd-POS CAL.”:(Recommended) Selecting this
option will measure a second
listening position for each
speaker and will produce the
best correction results. Please
place the microphone at ear
height in a secondary listening
position, such as in a seat next
to the first one that was
measured.
“2nd-POS BCAL.”: Selecting this option will
proceed with the calculation
using the first listening position
measurement only.
5. Select ENTER.
If you select the “B 2nd-POS CAL.”, the audyssey
2EQ automatic speaker setup is measured on the
second position. After completed, “CALIBRATING...”
appears for about 2 minutes in the display window.
If you select the “2nd-POS BCAL.”, “CALIBRATING...”
appears for about 2 minutes in the display window.
6. Check the result value of speaker size, level,
distance and X-OVER by pressing b/B/
vv
/
VV
,
ENTER.
You can only check the result values of the first
position.
Notes
If the result values of subwoofer is “NONE”, the
FRONT LR of SPK TYPE on the SETUP menu
are automatically set to “LARGE”.
The result values of the second position is not
measured the result value of speaker size, level,
distance and X-OVER but an optimum sound.
7. When “RESULT
BB
NO OK” appears in the
display window, select the “RESULT NO
BB
OK”
by pressing
bb
/
BB
and then select ENTER.
- The unit will automatically enter the Standby
mode.
- Selecting "RESULT
BB
NO OK" will restart the
Audyssey 2EQ Automatic Speaker Setup. The
previous measurements will be discarded.
8. Turn Audyssey 2EQ On or Off.
- Press AUTO CAL. on the remote control to turn
Audyssey 2EQ acoustical correction on or off.
Notes
Press AUTO CAL. for about 2 seconds to begin the
Audyssey 2EQ automatic speaker setup again.
If you want to cancel during the automatic speaker
setup process, press AUTO CAL. The “EXIT? > No
Yes” appears in the display window. Then select
“YES” by pressing b/B and then press ENTER.
If there is excessive noise during automatic speaker
setup. “SPK NOISE” appears in the display window.
Quiet the environment and begin the Audyssey 2EQ
automatic speaker setup again.
Disconnect the speaker setup microphone after
automatic speaker setup.