Filter
Top Products
Krell Current Tunnel 23
Zone 2 Only
1. With the KCT in the stand-by mode, press the zone button (10) or Z2 key (38). The
front panel display (13) shows zone 2 is active.
2. Press the input select key (39) to select the device you wish to play in zone 2. The
KCT will switch to the operational mode and the device will play in zone 2 only.
3. Press the zone button (10) or Z2 key (38) again. Zone 2 stops playing and the KCT
switches back to the stand-by mode.
Note:
When you press the power button (1) or key (32) to return to the operational mode, the
KCT is in the main zone.
Play and Record
This option allows you to play an input device through the main zone while sending
output from another device through zone 2 for recording. You can also record through
the main zone and listen through zone 2.
1. Press the power button (1) or key (32) to switch the KCT from the stand-by to the
operational mode. The front panel display shows the main zone is active, the
currently selected input, and main zone volume level.
2. Press the input select button (6) or key (39) to select the input device that you want to
play through the main zone.
3. Begin playing the device. Use the level control knob (14) or level keys (44) to adjust
the main zone volume to the desired listening level.
4. Press the menu button (15) or key (41) to select the main menu. The front panel
display (13) shows
MENU.
5. Use the level control knob (14) or level keys (44) to select the
TAPE OUTPUT MENU.
6. Press the enter button (16) or key (42) to access the submenu. The front panel
display shows
OUTPUT FROM ZONE1.
7. Use the level control knob (14) or level keys (44) to select
OUTPUT FROM ZONE2.
8. Press the menu button or key to exit the main menu.
9. Press the zone button (10) or Z2 key (38) to select zone 2.
10. Press the input select button (6) or key (39) to select the input device that you want
to record through zone 2. Begin playing the device.
11. Press the tape button (7) or key (40). The front panel display shows TAPEOUT ZONE2.
The input will begin recording through zone 2. The front panel display shows TAPE
MONITOR
after three seconds.
While you are recording through zone 2, you can also press the zone button (10) or
main zone key (37) to check playback through the main zone, without interrupting the
recording through zone 2.