Filter
Top Products
Krell Current Tunnel 15
Remote Control Description
See Figure 3 on page 14
BATTERY INSTALLATION AND REMOVAL
The KCT remote control uses two AAA-size 1.5 Volt batteries. Batteries are included
with the shipment. To install the batteries:
1. Remove the remote control backplate, using the supplied T-10 Torx wrench.
2. Install the batteries, following the battery position diagram on the plastic battery
receptacle.
3. Replace and secure the backplate.
Replace batteries when remote control function becomes intermittent.
Remove batteries if the remote control is not used for a long period of time. Battery
leakage can damage the remote control.
The remote control provides power on, input and zone selections, level and balance
control, menu, and compact disc functions. Remote control keys and their descriptions
follow.
Power
32 Power Key
Use this key to switch the KCT between the stand-by and the operational modes.
Amplifier Functions
33 Amp Pwr Key
Use this key to activate Krell amplifiers connected to your system. The amp pwr key
also activates the control component for amplifiers connected by Krell Link.
34 Amp Sel(ect) Key
Use this key to switch between CAST and balanced inputs on a Krell Full Power
Balanced amplifier connected to your system. The red center LED illuminates when the
CAST output is active.
Preamplifier Functions
35 Mute Key
Use this key to mute the preamplifier output. To unmute, press the mute key again. To
customize mute key operation, see Mute Menu, on page 29.
36 Phase Key
Use this key to invert the absolute polarity of the variable output 180 degrees for the
selected input. The front panel display (13) shows INVERT for the negative phase; the
display remains blank for the positive phase.