Kramer Electronics WP-220E Stereo System User Manual


 
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your WP-220E XGA/Audio/Video Line Driver
2
 2 video outputs (an amplified and equalized RGBHV output on 5 BNC
connectors, and a video output 2-pin connector that connects to the coax cable
(one pin is for the composite video signal, and the other is for the Ground))
 2 unbalanced stereo audio inputs (a PC audio input on a 3.5mm mini jack,
and an audio line input on left and right RCA connectors)
 2 balanced stereo audio outputs (a PC audio output on a terminal block
connector, and an audio line output on a terminal block connector)
In particular, the WP-220E has:
 Left and right audio level controls
 EQ. control to adjust the XGA cable compensation (equalization) level
 EQ., and level controls to adjust the CV cable compensation
(equalization) level
 Video bandwidth of 500MHz, that ensures transparent operation for all
resolutions
 A standard 12 Volt DC feed
Achieving the best performance means:
 Connecting only good quality connection cables, thus avoiding
interference, deterioration in signal quality due to poor matching, and elevated
noise levels (often associated with low quality cables)
 Avoiding interference from neighboring electrical appliances and
positioning your WP-220E away from moisture, excessive sunlight and dust
4 Your WP-220E XGA/Audio/Video Line Driver
This section defines the WP-220E XGA/Audio/Video Line Driver:
 Available in 3 versions (see section 4.1)
 Front panel (see section 4.2)
 Top side panel (see section 4.3)
 Lower side panel (see section 4.4)
 RGBHV Outputs (see section 4.5)