Kenwood XD-852 Stereo System User Manual


 
XD-SERIES (EN/M,T)
33
Basic section
4. Select the source to be recorded.
1 TUNER (Radio)
2 CD
3 TAPE (This source cannot be recorded.)
4 MD/DVD (External input)
(
Input level adjustment Q)
The input source component to
be recorded should be displayed.
÷ If a disc has already been loaded
when the CD input is selected, it
will starts to play automatically. In
this case, press the stop (&) key to
stop it.
Select an input source other
than “TAPE”.
1 Start recording.
2 Play (or tune) the input source to be recorded.
5. Start recording.
÷ Even if deck A is selected, it is
automatically switched to deck B
at the start of recording.
÷ Recording stops automatically
when the tape side(s) to be re-
corded have been fully recorded.
÷ Press the stop (&) key of the cas-
sette deck unit to stop recording.
C2D01 1:1
Lights
INPUT
44
REC/ARM
55
XD-6...seriesXD-7...series
XD-8...series
Let's record
The DOLBY NR system minimizes the hiss noise heard
when playing tape. When playing a tape prerecorded
with DOLBY NR ON, be sure to set the DOLBY NR ON
for playback.
Selection of DOLBY NR
(Noise Reduction)
(Main unit only) (XD-7...series, XD-8...series only)
Lit when “DOLBY NR” is ON.
DOLBY NR
To pause recording
(Main unit only)
÷ Pressing the key pauses recording after leaving a
non-recorded space of about 4 seconds.
÷ If the key is pressed again in less than 4 seconds after it
has been pressed, recording resumes from that instant.
Each press switches the modes as follows.
1
” .... Recording stops after having re-
corded both sides of tape.
2
” ... Recording stops after having re-
corded both sides of tape.
3
..... Recording stops after having re-
corded one side of tape.
Selection of the reverse mode
(Main unit only)
REC/ARM
REV. MODE
Lights
÷ Select the DOLBY NR mode according to the recording
condition of the tape.
Each press switches the modes as follows.
1 1 NR” ON .... DOLBY NR is used.
2 1 NR” OFF ... DOLBY NR is not used.
Dolby noise reduction manufactured under license from
Dolby Laboratories.
“DOLBY” and the double-D symbol are trademarks of
Dolby Laboratories.
XD-6...seriesXD-7...series
XD-8...series
÷ When the 2 transport direction indicator is lit,
recording always stops after having recorded one
side of tape.