Kenwood XD755 Stereo System User Manual


 
8
EN
PREPARATION FOR USE
Unplug the AC power cord from the AC socket before connecting or disconnecting any component.
Speaker Model
Name
System Name
Speaker connection
Connect each speaker wire to the SPEAKERS ter-
minals as shown. Use speakers with an impedance
of 6 or more, as lower impedance speakers can
damage the unit.
Connect the black wire to the minus (-) terminal,
and the red wire to the plus (+) terminal.
Caution :
Do not mix the right channel and left channel
wiring when connecting the speakers to the unit.
The right speaker is the one on the right side
when you are facing the front of the unit.
Do not let bare speaker wires touch each other
as this may damage the amplifier and/or speak-
ers.
Do not allow any objects to fall into or to be
placed in the bass reflex ducts.
Do not stand or sit on the speakers. If the speak-
ers fall or collapse, you may be injured.
XD-855 / XD-855E / XD855
XD-755 / XD-755E / XD755
LS-N90S
Right speaker
Left speaker
Red
Black
Red
Black
XD-655 / XD655
LS-N50S
LS-N70S
CAUTION
Be sure to adhere the followings, or proper ventilation will be blocked causing damage or fire
hazard.
÷ Do not place any objects impairing heat radiation onto the top of unit.
÷ Leave space around the unit (from the largest outside dimension including projection) equal to or
greater than, shown below.
Top panel : 50 cm Side panel : 10 cm Back panel : 10 cm