Kenwood TM-V7A Stereo System User Manual


 
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
77
MICROPHONE CONTROL
You can also make the following settings by pressing
[F]
first (ex.
[F]
, Mic [2]).
1
After activating the Tone function, press
[F]
, Mic [2], then
press [ ] or [#] to change the tone frequency.
2
U.S.A./ Canada only
Note:
U.S.A. only: It is illegal to transmit control codes on the VHF band.
Transmit control codes only on the UHF band.
You cannot activate both Volume Change and Squelch Adjustment at
the same time.
When you recall a memory channel containing DTSS or Page ON
status after activating Microphone Control, DTSS or Page will not
function.
6
C
2
3
5
Key
FunctionKey
Function
Tone Select
1
Offset Direction Select
DTMF Keypad Lock
DTMF Keypad Unlock
Repeater Function
2
You can change numerous transceiver settings with the
MC-53DM or MC-45DM microphone without using the
transceiver buttons or controls. DTMF tones are used for
this remote control operation. First switch Microphone
Control ON using Menu Set-up {page 78}.
Note: Audible DTMF tones from other transceivers near you may be
picked up by your MC-53DM or MC-45DM microphone. If so, this could
prevent the functions from working correctly.
The following table shows what function is switched ON
and OFF or which setting is changed by pressing the
DTMF keys.
1
Transceivers equipped with the optional VS-3 unit
announce the displayed information {page 82}.
2
After pressing this key, press [ ] to lower or [#] to raise
the level.
9
0
A
B
C
D
#
1
2
3
4
5
6
7
8
Key
FunctionKey
Visual Scan
Tone/ CTCSS
Reverse
1 MHz Step Change
Monitor
Frequency Readout
by Beeps
1
Volume Change
2
Dual Band RX
Squelch Adjustment
2
TX Power Change
Enter
Control Band Select
[F]
key
Frequency Down
Frequency Up
Function