Kenwood TM-V7A Stereo System User Manual


 
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
75
Memory Channel Number Entry
1 Select the desired band.
2 Press [MR] to enter Memory Recall mode.
3 Press the Mic key re-programmed with Enter.
"– –" or "– – –" appears depending on the number of
memory channels available on the current band.
4 Use the Mic keypad to enter 2 or 3 digits.
To recall channel 3, for example, enter "03" or "003".
If you press any key other than [0] ~ [9], or if you do
not make the next entry within 10 seconds, the
previous frequency display will be restored.
If you enter a memory channel that does not contain
data, an error beep sounds.
Tone Frequency Number Entry
1 Select the desired band.
2 Press
[TONE]
to activate the Tone function.
3 Press
[F] (1 s), [T.SEL]
.
The current tone frequency appears.
4 Press the Mic key re-programmed with Enter.
"– –" appears.
5 Use the Mic keypad to enter the Tone No.
corresponding to the desired tone frequency.
Consult the table given in "Selecting a Tone
Frequency" {page 25} to find out how the Tone Nos.
correspond to the tone frequencies.
To select Tone No. 3 (74.4 Hz), for example, enter
"03".
If you press any key other than [0] ~ [9], or if you do
not make the next entry within 10 seconds, the
previous frequency display will be restored.