Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
32
NAMING MEMORY CHANNELS
You can name memory channels using up to 7
alphanumeric characters. When you recall a named
memory channel, its name appears on the display with the
stored frequency. Names can be callsigns, repeater
names, cities, names of people, etc.
Note:
◆
You cannot use this function after having selected 140:140 memory
channel ratio.
◆
You cannot name the Call, L1 to L3, nor U1 to U3 channels.
1 Recall the desired memory channel.
2 Press [MNU] to enter Menu mode.
3 Select Menu No. 4 (Memory).
4 Press
[
ss
ss
s
]
, then select item No. 3 (Memory Name).
5 Press
[SET]
.
• The first digit blinks.
6 Turn the Tuning control, or press Mic [UP]/[DWN], to
select the first digit.
• To skip by four characters when operating the above
control or keys, press [MHz]. Press [MHz] again to quit
this jump function.
7 Press
[
ss
ss
s
]
.
• The second digit blinks.
8 Repeat steps 6 and 7 to enter up to 7 digits.
• After entering the 7th digit, pressing
[
ss
ss
s
]
causes an error
beep to sound.
• To re-enter the preceding digit, press
[
tt
tt
t
]
.
• To clear all digits and move back to the first digit, press
[VFO].
9 Press
[SET]
again to complete the setting.
10 Press [MNU] to exit Menu mode.
Note:
◆
Names can be assigned only to memory channels in which you have
stored frequencies and related data.
◆
The stored names can be overwritten by repeating steps 1 to 10.
◆
The stored names also are erased by clearing memory channels.
PWRPWR
VOL SQL
CALLCALL
2
PWRPWR
VOL SQL
CALLCALL
1
2
PWRPWR
VOL SQL
CALLCALL
1