Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
42
■ Using Visual Scan
1 Select the desired band.
2 Turn the Tuning control, or press Mic [UP]/[DWN],
to select the operating frequency.
• This frequency will also be used as the center
frequency.
3 Press
[F]
,
[VISUAL]
to start Visual Scan.
• To halt Scan, press
[PAUSE]
. "P" appears.
Press
[PAUSE]
again to resume.
4 To change the operating frequency, turn the Tuning
control or press Mic [UP]/[DWN].
• The displayed frequency changes and the cursor
moves.
• Press
[SET]
to use the changed operating frequency
as the center frequency.
• Press
[RESET]
to restore the previous operating
frequency.
5 To quit Visual Scan, press
[OFF]
.
Note:
◆
If you start Visual Scan in Memory Recall mode, the memory channel
frequencies will be scanned.
◆
If you start Visual Scan after recalling the Call channel, the call
channel frequency will be used as the center frequency.
◆
Visual Scan stops while transmitting.
◆
Starting Visual Scan switches Automatic Band Change OFF.
◆
If you start Visual Scan in one of the following conditions, you cannot
receive in the current operating frequency. To use this frequency,
press [PAUSE] to halt Scan.
•
Memory Recall or Call Channel mode
•
The VHF band, VFO mode, and a frequency in the range
118 MHz to 136 MHz were selected.
◆
Depending on conditions, Visual Scan and the conventional S-meter
may indicate different signal strength levels.