Filter
Top Products
18
Operations
KR-V888D (En/T)
1
Turn on the receiver.
Keys or controls used in this operation.
Listening to a source component
A ON :Sound from the speakers connected to the SPEAK-
ERS A terminals on the rear panel.
B ON :Sound from the speakers connected to the SPEAK-
ERS B terminals on the rear panel.
A+B ON :Sound from both the speakers connected to the
SPEAKERS A and B terminals on the rear panel.
A+B OFF : No sound from the speakers. Use this setting when
listening with headphones for stereo sound in all
playback modes.
•When both SPEAKERS A and B are ON, activating a surround mode
turns SPEAKERS B OFF automatically.
2
3
The indicator for the speakers you want to use should be lit.
5
4
Decrease volume Increase volume
Select a speaker system.
Select the source you desire.
Adjust the volume.
Start playback from the selected source.
Preparations
÷Turn on the power to the related compo-
nents.
÷Set the POWER key to the ON position.
Normal playback
A
SP.
PHONO
B
A
B
AUDIO
SHIFTMACRO
TVVIDEO
GUIDEREC
MUTE
VOLUMETUNING/SKIP
THEME FAVMENU
FUNCTION
SHIFT
SETUP
INFO ALT AUDTV/SAT/VID
REPEAT RANDOM+100
DISPLAY
ENT+10
LISTEN
MODE
SOUNDSUBWOOFER
564
231
897
0
8
7
4¢
6
BAND
P. CALL P. CALL
PHONES
1234567890
STANDBY
2-CH
DOWNMIX
LEVEL
INDICATOR
DIRECTMEMORY
ABSPEAKERS
AUTO
MUTE
TUNING BASS TREBLEBAND
LEVEL CONTROL
DOLBY
DIGITAL PRO LOGIC
3 STEREO STEREO
SOURCE DIRECT DSP
DIMMER
INPUT SELECTOR VOLUME CONTROL
VIDEO
ON/STANDBY
DOWN UP
L
-
AUDIO
-
R
LOUDNESS
TA/NEWS/INFO. PTY DISPLAY
+10/
PTY SEARCH
POWER
-ON–OFF
AV AUX
AUDIO−VIDEO SURROUND RECEIVER KR-V888D
TRAITR
thermally reactive advanced instantaneous transistor
POWER
POWER
-ON –OFF
ON/STANDBY
SPEAKERSA
B
INPUT SELECTOR
VOLUME CONTROL
DOWN
UP
The input sources change as shown below:
*Once setup codes are registered in the remote control, the input name
display changes according to the name of the registered component.
Example: if you register a VCR at the VIDEO 1 jacks, "VCR1" appears
instead of "VIDEO 1". °
•Both the default input name and the component type (i.e., " VIDEO1
'VCR1' ") are shown in the on screen display when the OSD mode is
set to ON. fl
•When using the remote control after initial setup, any inputs that have
not been registered with a setup code are deleted from the cyclic list
(except for the "AV AUX" VIDEO input). ‚
•The INPUT SELECTOR on the front panel of the receiver always cycles
through all inputs.
1 TUNER (Frequency display)
2 "PHONO"("PHONO"*)
3 "VIDEO1" ("SAT"*)
4 "VIDEO2" ("LD"*)
5 "VIDEO3" ("VCR"*)
6 "AV AUX"
7 "CD" ("CD"*)
8 "TAPE/MD" ("TAPE"*)