Filter
Top Products
5
EN
6543278 90 @!
#% $^
1
1 ON/STANDBY key
Use to turn the power ON/STANDBY.^
STANDBY indicator
Lights when the power is in the standby
mode.
2 F.AUX MODE key
Use to switch the status of FRONT AUX mode.
)
Use to switch the status of REC mode.
£
3 INPUT MODE key
Use to switch between the full auto, digital and
analog input.
7
4 SOUND key
Use to adjust the sound quality and the ambi-
ence effects.
(¤
5 MEMORY key
Use to store radio stations in the preset
memory.
¢§
6 BAND key
Use to select the broadcast band.
¢§
7 AUTO/MONO key
Use to select the auto or manual tuning
mode.
¢
8 Dolby D indicator
Lights when the receiver is in the Dolby
Digital mode.
º
DTS indicator
Lights when the receiver is in the DTS mode.
º
LOUDNESS indicator
Lights when the LOUDNESS mode is ON.
¡
9 MULTI CONTROL button
Use to control a variety of settings.
$^
0 ACTIVE EQ key
Use to switch the status of ACTIVE EQ.
¡
! VOLUME CONTROL knob
Use to adjust the receiver volume. )
@ INPUT SELECTOR key
Use to select input sources. )
Display
Speaker selection indicators,
Input channel indicators (The Input channel
indicators lights up to indicate the channels
contained in the input signal. The "S"
indicator lights when the surround
component consists of a single channel.)
ACTIVE EQ indicator,
96 kHz fs indicator
Frequency display,
Input display,
Preset channel display,
Listen mode display
MUTE indicator
CLIP indicator
Input mode indicators
Listen mode indicators
# SETUP key
Use to select the speakers' settings etc.
$^
$ LISTEN MODE key
Use to select the listening mode. º
% GAME/FRONT AUX jacks @)
^ PHONES jack
Use for headphone listening. ™
Sleep timer indicator, TONE indicator,
AUTO indicator, ST. indicator,
TUNED indicator,
For Europe and Australia :
RDS indicator, PTY indicator
View when the GAME/FRONT AUX jack cover is open.
Main unit
Names and functions of parts
Standby mode
While the standby indicator is lit, a small
amount of power is supplied to the system to
back up the memory. This is called standby
mode. Under the condition, the system can
be turned ON by the remote control unit.