Filter
Top Products
13
EN
ANTENNA
AM GND FM 75Ω
Setting up the system
Connecting the antennas
AM loop antenna
The supplied loop antenna is for use indoors. Place it as far as possible
from the receiver, TV set, speaker cords and power cord, and adjust the
direction for best reception.
AM antenna terminal connections
1 Push lever. 2 Insert cord. 3 Release lever.
FM indoor antenna
The supplied indoor antenna is for temporary use only. For stable signal
reception we recommend using an outdoor antenna. Disconnect the
indoor antenna when you connect one outdoors.
FM outdoor antenna
Lead the 75Ω coaxial cable connected to the FM outdoor antenna into the
room and connect it to the FM 75Ω terminal.
AM loop antenna
FM outdoor antenna
Use an antenna
adaptor
(Commercially
available)
Attach to
the stand
For the U.S.A. and Canada
Except for the U.S.A. and Canada
FM antenna terminal connections
Insert the connector
(For the U.S.A. and Canada)
(Except for the U.S.A. and Canada)
The broadcast reception cannot be made unless the antennas are
connected. Connect the antennas correctly as instructed below.
FM indoor antenna
FM indoor antenna
¶ When pressing more than one remote control key successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
Notes
1.The supplied batteries may have shorter lives than ordinary batteries
due to use during operation checks.
2.When the remote-controllable distance gets shorter than before,
replace both batteries with new ones.
3.Placing the remote sensor in direct sunlight, or in direct light from a
high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to
prevent malfunction.
Operating range
(Approx.)
Remote sensor
RECEIVER
6m (20 ft.)
Remote control operation
When the STANDBY indicator is lit, the power turns ON when you press
the
RECEIVER on the remote control. When the power comes ON,
press the key you want to operate.
¶ Insert two AAA-size (R03) batteries as indicated by the
polarity markings.
Preparing the remote control
Loading the batteries
1 Remove the cover. 2 Insert the batteries.
3 Close the cover.