Filter
Top Products
41
EN
Basic remote control operations for other components
Storing the remote control code of the other
components
The remote control unit can store the remote control code of the other
components and you can operate the other components from the remote
control unit. The remote control code is stored on the key or memory of
the remote control unit.
Storing on the key
You can store the remote control code to the key as shown below:
STANDBY
RECEIVER
SOURCE
TV
VIDEO2VIDEO1
DVD/6CH
PHONOMD/TAPE
CD/DVD
RCV MODEACTIVE EQ
TUNER
TV INPUT
TV MUTE
INFO
LOUDNESS
ANGLE
BASS BOOST
SUBTITLE
TONE
AUDIO
TOP MENU
/SETUP
RETURN
/EXIT
ON SCREEN
/GUIDE
MENU
/SOUND
ENTER
BAND
–
CHANNEL
+
MULTI
MULTI
DIMMER
DSP MODE
DOLBY VIRTUAL
AUTO/MONO SLEEP
PAG E
THXSTEREO
LISTEN MODE
LEARNLASTINPUT SEL.
DISC SKIP
DISC SEL.
INPUT MODE
RC-R0918
ON
VIDEO3
AV AUX
TV MODE
TV VOL.
MUTE
P. CALL TUNING
VOLUME
Numeric keys
Source keys
LCD
SOURCE
(Source power)
RETURN
DISC SEL.
CHANNEL –/+
4/¢ (Skip)
3/8 (Play/Pause)
DISC SKIP
LEARN
PAGE %/fi
7 (Stop)
¡ (Rewind)
1 (Fast forward)
1
Point the infrared ray system part of another remote control
unit to the remote sensor of the remote control unit.
Remote control
unit of the other
source.
Infrared ray system par
t
Remote sensor
2
Press and hold the LEARN key for 3 seconds until blinks
twice, then release the Learn key.
3
Press the Numeric key to enter
9
,
7
,
5
.
4
Press any of the Source keys (DVD/6CH, VIDEO 1, VIDEO 2,
VIDEO 3, CD/DVD, PHONO, AV AUX, MD/TAPE, TV MODE) to
select the input of the desired remote control unit.
• While in Tuner mode, learning code function is not available.
5
Press the desired key of the remote control unit.
• “LEARN” and appear on the display.
6
From the remote control unit of the other source, press the key
that you want to store.
• The remote control code is sent to the remote control unit.
• “OK” appears when finished.
• If the code cannot be stored after a few attempts, “ERROR” will
appear. Repeat from step 2 onwards.
7
The remote control code is stored on the key of this remote
control unit.
8
Repeat step
4
to
6
to store additional components until all
the desired components are stored.
9
To exit the learning mode, press and hold the LEARN key for
3 seconds until
blinks twice.
0
To clear the stored remote control code of the other sources:
1 Press and hold the LEARN key for 3 seconds until blinks
twice, then release the LEARN key.
2 Press the Numeric key to enter
9
,
7
,
6
.
3 Press the Source key, then press the stored key twice until
blinks twice.
•
blinks twice to indicate that the stored remote control code are
deleted.
05.2.21, 0:14 PM41