Filter
Top Products
40
EN
Basic remote control operations for other components
Operating other components
This operation lets you operate the registered components.
SOURCE
(Source power
)
Source keys
1
Use the Source keys to select the component you desire.
• Pressing the source keys also changes the input selector on the
receiver.
2
Press the SOURCE key.
• To return to the receiver operation mode, press the RCV MODE key.
3
Press the operation keys you desire.
y
The remote control mode remains at the selected input. If you
wish to operate another component, repeat step 2 or 3.
Resetting the Remote Control
• To initialize the remote control, press the LEARN key until the
blinks twice. Then press the Numeric key to enter 9, 8, 1. The
will blink twice.
4
Repeat step
3
three more times for the remaining digits. Use
“2” for the second digit, “3” for the third digit, and “4” for the
fourth digit.
5
To check the codes of your other components, repeat steps
1
through
4
, but substitute the appropriate key (i.e., DVD/
6CH, VIDEO 1, VIDEO 2, VIDEO 3, CD/DVD, MD/TAPE, PHONO,
AV AUX, TV MODE) for the component you are checking.
•As suggested earlier on, write down each of the four-digit code.
• PHONO key has to be re-assigned to another key before a setup
code can be programmed.
Re-assigning device keys
The remote control can be setup to control second TV or VCR, or any
combination of eight home entertainment components.
For example, to control the operation of two different VCR using the
remote control, the user need to re-assign the unused VIDEO 2 key to
operate the second VCR (VIDEO 1) as follows:
1
Press and hold the LEARN key until blinks twice, then
release the LEARN key.
2
Press the Numeric key to enter
9
,
9
,
2
.
• will blink twice.
3
Press VIDEO 1 key once, then press the VIDEO 2 key once.
•The user now can operate VIDEO 2 as a second VCR along with
VIDEO 1.
• Refer to the table in the previous page for the combination of
source keys and the other components assignment. ·
4
To re-assign other device keys, repeat steps
1
through
3
by
substituting the key sequence from the below chart for the
most popular components:
To re-assign key
Sequence Perform
TV MODE as 2nd VIDEO 1 key LEARN 9 9 2
VIDEO 1 TV MODE
TV MODE as 2nd VIDEO 2 key LEARN 9 9 2
VIDEO 2 TV MODE
TV MODE as 2nd CD/DVD key LEARN 9 9 2
CD/DVD TV MODE
TV MODE back to TV MODE key
LEARN 9 9 2
TV MODE TV MODE
VIDEO 1 as 2nd TV MODE key LEARN 9 9 2
TV MODE
VIDEO 1
VIDEO 1 as 2nd VIDEO 2 key LEARN 9 9 2 VIDEO 2 VIDEO 1
VIDEO 1 as 2nd CD/DVD key LEARN 9 9 2 CD/DVD VIDEO 1
VIDEO 1 back to VIDEO 1 key LEARN 9 9 2 VIDEO 1 VIDEO 1
5
To clear the re-assignment and reset the remote control to its
original operation mode:
1 Press and hold the LEARN key until blinks twice, then
release the LEARN key.
2 Press the Numeric key to enter 9 , 9 , 2.
3 Press VIDEO 2 key twice.
• When a re-assignment is done,
will blink twice to confirm your
choice. At that time, you will need to program the remote control
in order to control the new component.
• If an invalid key sequence is entered,
blink once and return to
normal operation.
• When in Tuner mode, re-assignment is not available.
05.2.18, 3:27 PM40