Filter
Top Products
VR2090!VR-208OiKRF-V88B ! DiKRF.V7771D tEn/K)
The sound quality and the volumes of the speakers can be adjusted as required,
Use the procedure on this page to adjust the audio individually, on a per.source or per-program (movie} basis.
The effects of the loudness and tone setups are applied only to the sounds output from the "L" and "R" front speakers.
The loudness or tone control effect is maximized when "Lstn Mode" is set to "Stereo",
Therefore, when the front speakers are set to "Nml" (Normal}, low-frequency components are output from the subwoofer so
the loudness and tone effects are minimized.
_m_ Select the "Main Menu" icon.
O Select the "Snd "° icon from the "Main Menu" screen to
display the "Sound" menu screen.
_='_ Perform operation in the "Sound" menu screen.
O Adjust the Loudness.
This can be switched between and On _Off.
SP Level : Speaker level
: Midnight
mode
_j) Set the midnight mode.
This setting is possibte only with the Dolby Digital {AC-3)
input source.
This can be switched in order of 1 -* 2 _ Off.
• When adjusting the TONe, go 7:ostep I_t
a When adjusting the speaker evel, go to step L_
_l Adjust the "Tone"
a Select the "Tone" icon in step m.
O Set "Tone" to "On" or "Off".
O Adjust "Treble".
O Adjust "Bass".
m
Adjust the "SP Level"
C :Center speaker
RS :Right Surround
speaker
LS :Left Surround
speaker
SW :Subwoofer
•Select the "SP Level" icon in step S.
• To return to step m from step I_1 select the "1_ " (checkmarkt
icon
• The speaker volumes adiusted here is only temporal,
These settings are returned to the setups made using "Setup"
chapter when the power is switched off or another input is
selected.
• The speakers which have not been set up in the "SP Selection"
or "SP Selection (Custom)" menu screen under the "Setup
Surround" menu are displayed as "- - -" in the "SP Level" menu
screer_,
O Adjust the level of each speaker.