Filter
Top Products
VR 2O90/VR 2080iKRF-V8881 D/KRF-V77710 _Er_iKI
Setup forplaying different CDsfromRoomA andRoqm: B
Preparation
eConnect the CD player(s) to the man unit, and perform the
operatons n "Assigning the connected components to the
selected inputs" and "Setup of Room A and Room B"
To play CD(s) in Room A and Room B, use one of the three
kinds of connection methods below.
Connecting a KENWOOD Multi-room capability CD player,
Connecting two CD players.
Connecting a CD player other than KENWOOD Multi-room
capability CD Player,
_ _:_ _ _r_" ,_ r_,J'-_..:_'_,= _:_ _O._ _ _ _.;s_,._ ,_,-, _ _;_,_ >_,. ,_,,_, _ _ _<-_.__,__._
Setup for playing CDs in Room A and Room B using a Multi-room capability CD Player
B Conneet the Multi-room capability CD player.
I o use the Multi-room capability CD Player from KENWOOD° connect its OUTPUT A to the "CD1" input jacks on the rear panel of the main
unit so that OUTPUT A is remote controlled as the CD1 input, Then con nect OUTPUT B to the CD2/TAPE2 MONITOR input jacks on the rear
panel so that OUTPUT B is remote controlled as the "CD2" input,
Connect the Multi-room capability CD Player and the main unit with a system control cord,
Operation in the "Setup Multi Room" menu.
* Display the "Setup Multi
Room" menu screen
e To listen n "Room A", set
"SPEAKERS A" to ON.
e Jo risten r/ "Room B'*, set
'*SPEAKERS B"° to ON
Operation for displaying the "Setup Multi Room" menu screen :
Select the "Main Menu" icon,
O Select the "Stp" icon,
_) Select the "Multi Room" icon.
Operation in the "Setup Multi Room" menu screen :
Q Select and set the "Multi Room" icon to "Yes".
Select and set the "Zone Select" icon to "Room A" or
"Room B" according to your location.
O Press and hold the "DISPLAY MODE" key on the main unit
for more than 2 seconds to set the IR RECEIVER location to
"IR RECEIVER B".
Operation in the "Setup Input" menu.
CD2/Ta
• Display the "Setup Input"
menu screen.
• In this SCreen, perform the
setup for controlling "CD2",
Operation for displaying the "Setup Input" menu screen :
O Select the "Main Menu" icon.
Select the "Stp" icon.
Select the "Input" icon.
Operation in the "Setup Input" menu screen :
O Select and set the "CD2/Tape2" icon to "CD2",
_l setup IR
I {system control code) asthe '*Setup IR" code. Also input "[8] [_ [] _[]" for the "CD2" input,